Post-fault voltage limit assessment for six-phase induction machines: a synchronous and slip frequency approach
Open Access
- 1 March 2025
- journal article
- Published by Institute of Advanced Engineering and Science in International Journal of Power Electronics and Drive Systems (IJPEDS)
- Vol. 16 (1) , 162-174
Abstract
Six-phase machine research has attracted a lot of attention lately, as seen by the large number of articles and case studies that have been written about it. Six-phase induction machines are prevalent due to their simplicity in construction. A fault-tolerance system is essential to guaranteeing machine operation that is both available and continuous in the event of a disruption or failure in the system. The operational topologies of dual three-phase (D3-IM) and symmetrical six-phase (S6-IM) induction machines were studied in this research. One open-phase fault (1OPF) is covered in the study, and different scenarios including the derating factor, neutral configuration, and maximum torque (MT) operational strategy are taken into account. Using MATLAB software, machine characteristics, machine equations, and Clarke's transformation show the fault-tolerant capability of each type of machine. Moreover, a MATLAB program is developed to assess post-fault voltage control limits, allowing for a comparison between current and voltage control limits. Simulated graph results depicting line-to-line voltages against synchronous and slip frequencies across all possible fault scenarios reveal distinct fault-tolerant capabilities between the two machine types. The comparative study shows that S6-IM offers better fault-tolerant capability than D3-IM based on both various synchronous and slip frequency approaches.Keywords
This publication has 38 references indexed in Scilit:
- Loss model based controller of fuzzy DTC driven induction motor for electric vehicles using optimal stator fluxe-Prime - Advances in Electrical Engineering, Electronics and Energy, 2023
- An Online Global Fault-Tolerant Control Strategy for Asymmetrical Multiphase Machines With Minimum losses in Full Torque Operation Range2022
- Modeling of Six-Phase Induction Machine with Two Isolated Neutrals under One Open Phase Fault2022
- Post-Fault Voltage Limit of Dual Three-Phase Induction Machine Against Slip Frequency with Single and Two Isolated Neutrals2022
- Fault tolerant capability of symmetrical multiphase machines under one open-circuit fault2016
- Calculation of derating factors based on steady-state unbalanced multiphase induction machine model under open phase(s) and optimal winding currentsElectric Power Systems Research, 2014
- Modeling and analysis of six-phase induction machine under fault condition2009
- Modeling, simulation and experimental validation of a generation system for Medium-Voltage DC Integrated Power Systems2009
- Diagnosis of Speed Sensor Failure in Induction Motor Drive2007
- A high power density converter system for the Gamesa G10x 4,5 MW wind turbine2007