Methodology for the selection of long‐medium‐voltage power cable configurations
Open Access
- 1 May 2013
- journal article
- research article
- Published by Institution of Engineering and Technology (IET) in IET Generation, Transmission & Distribution
- Vol. 7 (5) , 526-536
Abstract
Single conductor cables are widely used in several types of installations over the last years, including the interconnection of wind parks to the power grid. Owing to the complexity of cable installations each configuration must be treated individually, regarding the use of sheath cross‐bonding, the influence of grounding resistances and the use of sheath voltage limiters. In this study, a systematic investigation of the performance of a long‐medium‐voltage cable configuration is presented. Sheath voltages and currents are calculated during steady‐state and short‐circuit conditions for varying sheath arrangements using the ATP/EMTP software. Results are validated by field measurements. The analysis is also extended to include the investigation of overvoltages in the installation, during slow and fast transients, according to the basic insulation level for the cable system.Keywords
This publication has 14 references indexed in Scilit:
- On the Choice Between Transmission Line Equations and Full-Wave Maxwell's Equations for Transient Analysis of Buried WiresIEEE Transactions on Electromagnetic Compatibility, 2008
- External impedance and admittance of buried horizontal wires for transient studies using transmission line analysisIEEE Transactions on Dielectrics and Electrical Insulation, 2007
- Parameter Determination for Modeling System Transients—Part II: Insulated Cables IEEE PES Task Force on Data for Modeling System Transients of IEEE PES Working Group on Modeling and Analysis of System Transients Using Digital Simulation (General Systems Subcommittee)IEEE Transactions on Power Delivery, 2005
- A Method of a Lightning Surge Analysis Recommended in Japan Using EMTPIEEE Transactions on Power Delivery, 2005
- Simulation studies to improve design for midlife 275-kV cable refurbishmentIEEE Transactions on Power Delivery, 2003
- A universal model for accurate calculation of electromagnetic transients on overhead lines and underground cablesIEEE Transactions on Power Delivery, 1999
- Calculation of voltage profiles along transmission linesIEEE Transactions on Power Delivery, 1997
- Simulation of transients in underground cables with frequency-dependent modal transformation matricesIEEE Transactions on Power Delivery, 1988
- Zinc Oxide Sheath Voltage Limiter for HV and EHV Power Cable: Field Experience and Laboratory TestsIEEE Transactions on Power Delivery, 1986
- Sheath Overvoltages in High-Voltage Cables Resulting from Special Sheath-Bonding ConnectionsIEEE Transactions on Power Apparatus and Systems, 1965