Effect of Low Cu Content and Heat Treatment on the Microstructure and Mechanical Properties of High-Vacuum Die-Cast AlSiMgMn Alloys
- 18 January 2023
- journal article
- research article
- Published by Springer Nature in JOM
- Vol. 75 (4) , 1345-1356
Abstract
No abstract availableKeywords
Funding Information
- The Key Area Research and Development Program of Guangdong Province (2020B010186002)
- National Natural Science Foundation of China (51875211)
- Natural Science Foundation of Guangdong Province (2021A151510042)
- the Fundamental Research Funds for the Central Universities and Supported by Beijing Natural Science Foundation (L223001)
This publication has 29 references indexed in Scilit:
- Revisiting the role of peritectics in grain refinement of Al alloysActa Materialia, 2013
- Study of intergrown L and Q′ precipitates in Al–Mg–Si–Cu alloysScripta Materialia, 2011
- Tensile properties and fracture behavior of partial squeeze added slow shot die-cast A356 aluminum alloyMaterials & Design (1980-2015), 2010
- Dislocation analysis of die-cast Mg–Al–Ca alloy after creep deformationMaterials Science and Engineering: A, 2009
- Experimental and numerical analysis of gas entrapment defects in plate ADC12 die castingsJournal of Materials Processing Technology, 2009
- The effect of average cooling rates on the microstructure of the Al–20% Si high pressure die casting alloy used for monolithic cylinder blocksJournal of Materials Processing Technology, 2008
- Influence of Cu content on ageing behavior of AlSiMgCu cast alloysMaterials & Design (1980-2015), 2007
- Influence of Cu on the mechanical properties and precipitation behavior of AlSi7Mg0.5 alloy during aging treatmentScripta Materialia, 2006
- Effects of Si content on defect band formation in hypoeutectic Al–Si die castingsMaterials Science and Engineering: A, 2005
- Effect of copper and solidification conditions on the microstructure and mechanical properties of Al–Si–Mg alloysJournal of Materials Processing Technology, 2004