Investigation of the Motion of Bubbles in a Centrifugal Pump Impeller
- 4 October 2018
- journal article
- research article
- Published by ASME International in Journal of Fluids Engineering
- Vol. 141 (3)
Abstract
Centrifugal pumps operate below their nominal capacity when handling gas–liquid flows. This problem is sensitive to many variables, such as the impeller speed and the liquid flow rate. Several works evaluate the effect of operating conditions in the pump performance, but few bring information about the associated gas–liquid flow dynamics. Studying the gas phase behavior, however, can help understanding why the pump performance is degraded depending on the operating condition. In this context, this paper presents a numerical and experimental study of the motion of bubbles in a centrifugal pump impeller. The casing and the impeller of a commercial pump were replaced by transparent components to allow evaluating the bubbles' trajectories through high-speed photography. The bubble motion was also evaluated with a numerical particle-tracking method. A good agreement between both approaches was found. The numerical model is explored to evaluate how the bubble trajectories are affected by variables such as the bubble diameter and the liquid flow rate. Results show that the displacement of bubbles in the impeller is hindered by an increase of their diameter and impeller speed but facilitated by an increase of the liquid flow rate. A force analysis to support understanding the pattern of the bubble trajectories was provided. This analysis should enlighten the readers about the dynamics leading to bubble coalescence inside an impeller channel, which is the main reason behind the performance degradation that pumps experience when operating with gas–liquid flows.Keywords
This publication has 25 references indexed in Scilit:
- Modeling Two-Phase Flow Inside an Electrical Submersible Pump StageJournal of Energy Resources Technology, 2011
- CFD Analysis of Electric Submersible Pumps (ESP) Handling Two-Phase MixturesJournal of Energy Resources Technology, 2004
- Two-equation eddy-viscosity turbulence models for engineering applicationsAIAA Journal, 1994
- Three-Dimensional Calculation of Air-Water Two-Phase Flow in Centrifugal Pump Impeller Based on a Bubbly Flow ModelJournal of Fluids Engineering, 1993
- Numerical study of the turbulent flow past an airfoil with trailing edge separationAIAA Journal, 1983
- Pressure Distribution In a Centrifugal Impeller Handling Air-Water MixturesBulletin of JSME, 1983
- A Theoretical Study on Air Bubble Motion in a Centrifugal Pump ImpellerJournal of Fluids Engineering, 1980
- Effects of Running Clearance of Semi-Open Impeller Pumps under Air Admitting ConditionsBulletin of JSME, 1976
- Effects of Entrained Air on the Performance of Centrifugal Pumps : 2nd Report, Effects of number of bladesBulletin of JSME, 1974
- Effects of Entrained Air on the Performance of a Centrifugal Pump : 1st Report, Performance and Flow ConditionsBulletin of JSME, 1974