Aluminium-Assisted Alloying of Carbon Steel in Submerged Arc Welding with Al-Cr-Ni Unconstrained Metal Powders: Thermodynamic Interpretation of Gas Reactions
Open Access
Abstract
Unconstrained metal powders of chromium and nickel, in combination with aluminium, were used in the submerged arc welding (SAW) process to simplify weld metal alloying. Unconstrained metal powders refer to non-alloyed metal powders that are not constrained in tubular wire, such as fluxed-cored and metal-cored wire. Aluminium powder is used to control the oxygen potential at the molten flux–weld pool interface. The results presented here show that the addition of aluminium powder to the weld metal enhances Cr and Ni yields to 89% for Cr and 91% for Ni, compared to lower values reported in pre-alloyed powder application. Alloying of the carbon steel in the base plate and weld wire combination was achieved at 6.0% Cr, 6.2% Ni, and 4.5% Al, with the weld metal oxygen controlled to 162 ppm O. Thermodynamic analysis was applied to investigate the likely gas reactions in the arc cavity emanating from the chemical interaction between Cr, Ni, and Al. The effects of gas-based chemical reactions on the yield of Cr and Ni to the weld pool are discussed and incorporated into our SAW reaction flow diagram. Overall SAW process productivity gains can be accomplished by using unconstrained metal powders to alloy the weld metal because expensive and time consuming steps, such as the manufacturing of alloyed wire and alloyed powder, can now be eliminated.Keywords
Funding Information
- National Research Foundation (BRIC171211293679)
This publication has 24 references indexed in Scilit:
- Low-Density Steels: The Effect of Al Addition on Microstructure and PropertiesJOM, 2014
- Effects of flux composition on the element transfer and mechanical properties of weld metal in submerged arc weldingMetals and Materials International, 2009
- Influence of the chemical composition of flux on the microstructure and tensile properties of submerged-arc weldsJournal of Materials Processing Technology, 2005
- Aluminum deoxidation equilibrium in liquid Fe-16 pct Cr alloyMetallurgical and Materials Transactions B, 2005
- Slag-metal reactions during welding: Part III. Verification of the TheoryMetallurgical Transactions B, 1991
- Slag-metal reactions during welding: Part II. TheoryMetallurgical Transactions B, 1991
- Slag-metal reactions during welding: Part I. Evaluation and reassessment of existing theoriesMetallurgical Transactions B, 1991
- Mechanisms of inclusion formation in Al−Ti−Si−Mn deoxidized steel weld metalsMetallurgical Transactions A, 1989
- Slag Metal Reactions during Submerged Arc Welding of Alloy SteelsMetallurgical Transactions A, 1984
- Slag-metal equilibrium during submerged arc weldingMetallurgical Transactions B, 1981