Underwater Laser Micromilling of Commercially-Pure Titanium Using Different Scan Overlaps
Open Access
- 25 January 2018
- conference paper
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 303 (1) , 012015
Abstract
Underwater laser milling process is a technique for minimizing the thermal damage and gaining a higher material removal rate than processing in air. This paper presents the effect of laser scan overlap on cavity width, depth and surface roughness in the laser milling of commercially-pure titanium in water. The effects of laser pulse energy and pulse repetition rate were also examined, in which a nanosecond pulse laser emitting a 1064-nm wavelength was used in this study. The experimental results indicated that a wide and deep cavity was achievable under high laser energy and large scan overlap. According to the surface roughness, the use of high pulse repetition rate together with low laser energy can promote a smooth laser-milled surface particularly at 50% scan overlap. These findings can further suggest a suitable laser micromilling condition for titanium in roughing and finishing operations.Keywords
This publication has 8 references indexed in Scilit:
- Dynamic features of bubble induced by a nanosecond pulse laser in still and flowing waterOptics & Laser Technology, 2018
- Cavity formation and surface modeling of laser milling process under a thin-flowing water layerApplied Surface Science, 2016
- Surface Morphology of Silicon Induced by Laser Ablation in Flowing WaterMaterials Science Forum, 2016
- Bubble Formation in the Underwater Laser Ablation of SiliconApplied Mechanics and Materials, 2016
- Laser ablation of silicon in water under different flow ratesThe International Journal of Advanced Manufacturing Technology, 2014
- Modeling nanosecond pulsed laser ablation: A focus on temperature dependence of material propertiesManufacturing Letters, 2014
- Investigation of CFRP laser milling using a 30W Q-switched Yb:YAG fiber laser: Effect of process parameters on removal mechanisms and HAZ formationComposites Part A: Applied Science and Manufacturing, 2013
- A Comparison of Dry and Underwater Laser Micromachining of Silicon SubstratesKey Engineering Materials, 2010