Preparation and Tribological Behavior of Carbon Fiber Reinforced Pantograph Slide Plate
Authors:
- 1 January 2012
- journal article
- Published by Trans Tech Publications, Ltd. in Advanced Materials Research
- Vol. 430-432, 378-382
Abstract
The carbon fiber (CF) reinforced pantograph sliding plates were fabricated by hot pressing with modified phenolic resin as bonder, and the continuous carbon fiber, copper and graphite respectively were reinforcing phase, electric conductive phase and lubricating phase, respectively. The impact toughness, electric resistance and wear resistance of the slide plate were tested. The structural characteristics of the pantograph sliding plates were investigated by scanning electron microscopy (SEM). The results show that the addition of CF mass fraction can increase impact strength and density; while resistivity has a lower trend; the volume abrasion loss and friction coefficient are decreased then increased dramatically. The fiber and resin interface adhesion is good for specimen impact cross section smooth. In addition, adhesive wear and abrasive wear are the main wear form of pantograph slide plates.Keywords
This publication has 9 references indexed in Scilit:
- Preparation of PAN/phenolic-based carbon/carbon composites with flexible towpreg carbon fiberMaterials Science and Engineering: A, 2008
- Friction and wear of rare earths modified carbon fibers filled PTFE composite under dry sliding conditionApplied Surface Science, 2007
- Sliding wear behavior of copper alloy contact wire against copper-based strip for high-speed electrified railwaysWear, 2007
- Electrical conductivity of self-monitoring CFRCCement and Concrete Composites, 2005
- Microstructure and tensile properties of 2014 Al alloy reinforced with continuous carbon fibers manufactured by gas pressure infiltrationMaterials Science and Engineering: A, 2005
- Failure analysis of a railway copper contact stripEngineering Failure Analysis, 2004
- A novel electrical contact material with improved self-lubrication for railway current collectorsWear, 2001
- The effect of coupling agent on electrical and mechanical properties of carbon fiber/phenolic resin compositesPolymer, 2000
- The surface chemistry and acid–base properties of a PAN-based carbon fibreCarbon, 2000