Anthropometric measurements to design best-fit femoral stem for the Indian population
Authors:
Open Access
- 1 February 2012
- journal article
- research article
- Published by Springer Nature in Indian Journal of Orthopaedics
- Vol. 46 (1) , 46-53
Abstract
Background: The standard commercially available marketed prostheses sometimes may not be the best fit to Indian patients because of the large anatomic variation. Orthopedic surgeons always stress the need for a proper implant-patient match in hip joint replacements, in particular, for a cementless femoral stem. The complications of mismatch are aseptic loosening, improper load distribution, and discomfort. The present study was undertaken to compare the differences in dimensions between femurs of elderly Indians and those of populations from other regions in order to solve the problem of a possible geometric mismatch between a selected implant and the hip joint as far as Indian patients are concerned. Materials and Methods: Measurements were made using computer aided design techniques on computed tomography (CT) scanned images of 98 femurs (56 left and 42 right). The software used to convert the CT images into solid models was MIMICS® (Materialize, Inc., Leuven, Belgium). The geometrical parameters, viz., the femoral head offset, femoral head center (HC), femoral head diameter, femoral head relative position, position of shaft isthmus, neck-shaft angle, bow angle, femoral neck length, canal flare index, femoral length, and canal width at various locations, were chosen to design best-fit standard femoral stems for cementless insertion. These data were compared with the published data of other countries. Results: A difference of 16.8% was found in the femoral head offset between Indian and Swiss populations, which can affect soft tissue tension and range of motion. At a distance of 20 mm above the lesser trochanter (LT), the anteroposterior (AP) canal width was found to differ by 45.4%, when compared with a French population which can affect the mechanical stability of femoral stem. Femoral dimensions of Indian male and female subjects have also been compared and differences evaluated. At the LT, the aspect ratio (ratio of mediolateral canal width and AP canal width) in case of males (1.198) is approximately13% higher than that of females (1.059). Conclusions: This study indicates a need for redesign of femoral stems. The obtained anthropometric femoral dimensions can be used to design and develop indigenous hip joint prosthesis in India. The results of this study can also be used in forensic anthropometric studies.Keywords
This publication has 37 references indexed in Scilit:
- Femoral neck anteversion, acetabular anteversion and combined anteversion in the normal Indian adult population: A computed tomographic studyIndian Journal of Orthopaedics, 2010
- Using two palpable measurements improves the subject-specific femoral modelingJournal of Biomechanics, 2009
- The Effect of Stem Alignment on Results of Total Hip Arthroplasty with a Cementless Tapered-Wedge Femoral ComponentThe Journal of Arthroplasty, 2008
- Morphologic Features of the Acetabulum and FemurClinical Orthopaedics and Related Research, 2001
- Geometric Mismatch of the Gamma Nail to the Chinese FemurClinical Orthopaedics and Related Research, 1996
- Closeness of fit of uncemented stems improves the strain distribution in the femurJournal of Orthopaedic Research, 1995
- Cementless Total Hip ArthroplastyClinical Orthopaedics and Related Research, 1983
- Anatomy of the Femoral Neck and Head, with Comparative Data From Caucasians and Hong Kong ChineseClinical Orthopaedics and Related Research, 1980
- Aging changes in the medullary cavity of the proximal femur in American Blacks and WhitesAmerican Journal of Physical Anthropology, 1979
- Factors governing the mechanical behavior of the implant-porous coating-trabecular bone interfaceJournal of Biomechanics, 1978