Three-body Abrasive Wear Behavior of Filled Epoxy Composite Systems
Authors:
- 31 July 2008
- journal article
- research article
- Published by SAGE Publications in Journal of Reinforced Plastics and Composites
- Vol. 28 (2) , 225-233
Abstract
Particulate filled epoxy composites have been studied for the three-body abrasive wear behavior using the rubber wheel abrasion test (RWAT) apparatus. The epoxy composites were fabricated with 0—20 wt% of the boron carbide in steps of 5wt%. In the present investigation, angular silica sand particles of size in the range 200—250 μm were used as dry and loose abrasives. The wear volume and wear rate were determined as a function of abrading distance. The filler additions have shown significant influence on three-body abrasive wear behavior at different loads. It was observed that inclusion of boron carbide filler in particulate form into epoxy matrix showed improved abrasion resistance. Scanning electron microscopy was used to study the worn surface features to understand the mechanisms involved in the removal of material.Keywords
This publication has 13 references indexed in Scilit:
- Development of UHMWPE modified PP/PET blends and their mechanical and abrasive wear behaviorPolymer Composites, 2007
- Two-body and three-body abrasive wear behaviour of polyaryletherketone compositesPolymer Testing, 2003
- A polyethylene-reinforced polymer composite abraded by bulk solidsWear, 2001
- Sliding wear of PP/UHMWPE blends: effect of blend compositionWear, 2001
- Wear mechanisms in polymer matrix composites abraded by bulk solidsWear, 2000
- Two-body and three-body abrasion: A critical discussionWear, 1998
- Resistance to particle abrasion of selected plasticsWear, 1997
- On the abrasive wear behaviour of mineral filled polypropyleneTribology International, 1996
- Influence of fillers and fibre reinforcement on abrasive wear resistance of some polymeric compositesWear, 1990
- The abrasive wear behaviour of continuous fibre polymer compositesJournal of Materials Science, 1987