Combined Inkjet Printing and Infrared Sintering of Silver Nanoparticles using a Swathe-by-Swathe and Layer-by-Layer Approach for 3-Dimensional Structures
Open Access
- 17 January 2017
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 9 (7) , 6560-6570
Abstract
Despite the advancement of additive manufacturing (AM)/3-dimensional (3D) printing, single-step fabrication of multifunctional parts using AM is limited. With the view of enabling multifunctional AM (MFAM), in this study, sintering of metal nanoparticles was performed to obtain conductivity for continuous line inkjet printing of electronics. This was achieved using a bespoke three-dimensional (3D) inkjet-printing machine, JETx, capable of printing a range of materials and utilizing different post processing procedures to print multilayered 3D structures in a single manufacturing step. Multiple layers of silver were printed from an ink containing silver nanoparticles (AgNPs) and infrared sintered using a swathe-by-swathe (SS) and layer-by-layer sintering (LS) regime. The differences in the heat profile for the SS and LS was observed to influence the coalescence of the AgNPs. Void percentage of both SS and LS samples was higher toward the top layer than the bottom layer due to relatively less IR exposure in the top than the bottom. The results depicted a homogeneous microstructure for LS of AgNPs and showed less deformation compared to the SS. Electrical resistivity of the LS tracks (13.6 ± 1 μΩ cm) was lower than the SS tracks (22.5 ± 1 μΩ cm). This study recommends the use of LS method to sinter the AgNPs to obtain a conductive track in 25% less time than SS method for MFAM.Keywords
Funding Information
- Engineering and Physical Sciences Research Council (EP/I033335/2)
- Directorate-General for Research and Innovation
This publication has 61 references indexed in Scilit:
- Multiprocess 3D printing for increasing component functionalityScience, 2016
- 3D Printing of Biocompatible Supramolecular Polymers and their CompositesACS Applied Materials & Interfaces, 2016
- Multi-functional 3D printed and embedded sensors for satellite qualification structures2015
- 3D-printed microelectronics for integrated circuitry and passive wireless sensorsMicrosystems & Nanoengineering, 2015
- Embedded 3D Printing of Strain Sensors within Highly Stretchable ElastomersAdvanced Materials, 2014
- 3D Printing multifunctionality: structures with electronicsThe International Journal of Advanced Manufacturing Technology, 2014
- A Simple, Low-Cost Conductive Composite Material for 3D Printing of Electronic SensorsPLOS ONE, 2012
- All-inkjet-printed electrical components and circuit fabrication on a plastic substrateMicroelectronic Engineering, 2012
- Inkjet Printed, Self Powered, Wireless Sensors for Environmental, Gas, and Authentication-Based SensingIEEE Sensors Journal, 2011
- Inkjet printed electronics for multifunctional composite structureComposites Science and Technology, 2009