Numerical evaluation of transient flow characteristics in a transonic centrifugal compressor with vaned diffuser
Authors:
- Ali ZamiriAZAli Zamiri
- Byung Ju LeeBLByung Ju Lee
- Jin Taek ChungJCJin Taek Chung
- 1 November 2017
- journal article
- Published by Elsevier in Aerospace Science and Technology
- Vol. 70, 244-256
Abstract
No abstract availableFunding Information
- Korea Institute of Energy Technology Evaluation and Planning
- Ministry of Education (NRF-2013R1A1A2013701)
- Ministry of Trade, Industry and Energy (20144010200770)
- National Research Foundation of Korea
This publication has 20 references indexed in Scilit:
- Numerical Simulation of Stall Inception Mechanisms in a Centrifugal Compressor With Vaned DiffuserJournal of Turbomachinery, 2016
- Full-annulus simulation of the surge inception in a transonic centrifugal compressorJournal of Thermal Science, 2015
- Large Eddy Simulation for a Deep Surge Cycle in a High-Speed Centrifugal Compressor With Vaned DiffuserJournal of Turbomachinery, 2015
- Performance Investigation Into Supersonic Diffuser for a High Pressure Centrifugal Compressor2014
- Temporal behaviour of a corner separation in a radial vaned diffuser of a centrifugal compressor operating near surgeJournal of Thermal Science, 2013
- Study and Control of a Radial Vaned Diffuser StallInternational Journal of Rotating Machinery, 2012
- Experimental and Numerical Investigation of Tip Clearance and Bleed Effects in a Centrifugal Compressor Stage With Pipe DiffuserJournal of Turbomachinery, 2012
- Analysis of the flow in a transonic centrifugal compressor stage from choke to surgeProceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy, 2011
- Experimental and numerical investigation of the flow field in a high-pressure centrifugal compressor impeller near surgeProceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy, 2009
- Effect of the Unsteadiness on the Diffuser Flow in a Transonic Centrifugal Compressor StageInternational Journal of Rotating Machinery, 2009