Tide Flow: A Low Rate Density Driven Cementing Technique for Highly Deviated Wells

Authors:

Abstract
SPE and IADC Members Abstract Over the last five to ten years the oil industry has undergone major changes. Increased focus on increased recovery has led to the development of techniques aimed at achieving longer, highly deviated and horizontal wells which penetrate several targets in a given reservoir. This paper outlines an alternative cementing technique to the more common turbulent or effective laminar placements and describes two cases where this technique were used at the Gullfaks Field. By using of the density difference between the displaced and the displacing fluids, the mud in the narrow part of the annulus will float up into the wide part of the annulus and be carried away. The effect will be optimised with the use of a low pumping rate, which improves the ability of the fluids to exchange. This technique can be more cost effective than stage-cementing or increasing the hole diameter. This technique is recommended when turbulent or effective laminar displacement is difficult. Introduction Problem definition. When drilling multi-target wells a major concern is to manage the hydraulics. Formations with different formation strengths and pore pressures can be exposed without operational problems. It is a challenge to cement long, high inclination hole sections where both depleted and undepleted zones have been penetrated. A new cement placement technique has been evaluated in order to reduce the equivalent circulating densities and obtaining proper displacement at the same time. Geology on Gullfaks. The Gullfaks Field is located in block 34/10 in the Norwegian North Sea sector. The field has three separate Gravity Based Structure platforms, the Gullfaks A, B and C. Production started in December 1986 on the Gullfaks A and the last platform, Gullfaks C, came on stream in December 1989. The production is mainly from three Jurassic sand reservoirs, the Statfjord formation, the Cook formation and the Brent Group. As a result of geological deformation, the Gullfaks Field consists of rotated fault blocks with low-angle normal faults dipping to the east and with a typical spacing of 1000 - 1500 m. In addition many small-scale, east/west trending normal faults occur. While most faults were non-sealing during hydrocarbon migration and reservoir filling, several faults act as barriers during production, limiting horizontal flow and pressure communication across the field. Initial reservoir pressures are normally around 310 - 320 bar at datum depth (1850 m total vertical depth (TVD), mean sea level (MSL)) and numerous hydrocarbon contacts are found throughout the field. Reservoir limitations. At the datum line (1850 m TVD MSL) the pore pressures are 310 - 320 bar, with minimum horizontal stress ( ) 352 - 375 bar. This gives a very small margin between pore pressure and fracture pressure. Experience from "Mini-Frac" tests performed on the Gullfaks Field, shows a connection between reduction in fracture pressure and reduction in pore pressure. A reduction due to depletion in one zone, can result in a fracture pressure lower than the pore pressure of other zones above or below. Case description. The Gullfaks well, C-23, was planned to be drilled to a total depth (TD) at 2534m TVD/5575m measured depth (MD), the final 400 m being an option if hydrocarbons were found in the Statfjord formation. The maximum well inclination in the reservoir section was planned to be 86e. The producing reservoirs would be the Brent Group, the Cook formation and the Statfjord formation, if hydrocarbon bearing. All production zones were depleted to some extent. The greatest challenge was to isolate the upper reservoir, the Ness formation (Brent Group). This reservoir was located just beneath the previous casing shoe from 1943m to 1924m TVD. The pressure gradient for C-23 is shown in Figure-1. The C-24 well did not have the same degree of complexity as C-23, but the casing design in both wells had to be changed to accommodate cement pumping hydraulics. P. 357