Even harmonic resonant class E tuned power amplifier without RF choke
Authors:
- 1 January 1996
- journal article
- research article
- Published by Wiley in Electronics and Communications in Japan (Part I: Communications)
- Vol. 79 (1) , 23-30
Abstract
A method for designing an amplifier that does not need an RF choke coil is proposed. This is accomplished by adding a shunt capacitor to a class E amplifier with a shunt inductor; this creates class E switching where higher harmonics are induced in the inductor‐fed input waveform. A design method is derived by performing an analysis of the circuit assuming load current is sinusoidal. Because the switch current is smaller than that of conventional class E amplifiers (with the same output power), the losses due to the series saturation resistance of the switch device are greatly reduced for the proposed amplifier. A 96‐percent RF conversion efficiency for 2 W of output power was obtained in experiments using a 2‐MHz switch using the proposed design.Keywords
This publication has 9 references indexed in Scilit:
- An exact analysis of class E amplifiers with finite DC-feed inductance at any output QIEEE Transactions on Circuits and Systems, 1990
- The infeasibility of a zero-current switching class-E amplifierIEEE Transactions on Circuits and Systems, 1990
- Class E Power Amplifiers and Frequency Multipliers with finite DC-Feed InductanceIEEE Transactions on Circuits and Systems, 1987
- Idealized Operation of Class E Frequency MultipliersIEEE Transactions on Circuits and Systems, 1986
- Collector amplitude modulation of the class E tuned power amplifierIEEE Transactions on Circuits and Systems, 1984
- Class E tuned power amplifier with shunt inductorIEEE Journal of Solid-State Circuits, 1981
- Transistor power losses in the class E tuned power amplifierIEEE Journal of Solid-State Circuits, 1978
- Harmonic output of class-E RF power amplifiers and load coupling network designIEEE Journal of Solid-State Circuits, 1977
- Class E-A new class of high-efficiency tuned single-ended switching power amplifiersIEEE Journal of Solid-State Circuits, 1975