In situ ultrahigh vacuum residual gas analyzer “calibration”
Authors:
- 30 October 2008
- journal article
- Published by American Vacuum Society in Journal of Vacuum Science & Technology A
- Vol. 26 (6) , 1474-1479
Abstract
Knowing the residual gas spectrum is essential for many applications and research in ultrahigh vacuum (UHV). Residual gas analyzers (RGAs) are used for both qualitative and quantitative gas analyses, where the quadrupole mass analyzers are now the most popular. It was found that RGAs supplied by different manufacturers are not necessarily well calibrated for quantitative gas analysis. A procedure applied for in situ RGA “calibration” against a calibrated UHV total pressure gauge is described in this article. It was found that special attention should be paid to H2 calibration, as RGAs are usually much more sensitive to H2 than ionization gauges. The calibration coefficients are quite reproducible in Faraday cup mode, however, using the secondary electron multiplier requires frequent checks of the calibration coefficients. The coefficients obtained for the RGA allow the use of the RGA as an accurate device for gas spectrum analysis.Keywords
This publication has 4 references indexed in Scilit:
- Recommended Practice for the Calibration of Mass SpectrometersJournal of Vacuum Science & Technology A, 1993
- Total and Partial Pressure Measurement in Vacuum Systems1988
- Mass-dependent effects of channel electron multipliers in residual gas analyzersJournal of Vacuum Science & Technology A, 1987
- Long-term changes in the sensitivity of quadrupole mass spectrometersJournal of Vacuum Science & Technology A, 1986