Microtensile bond strength of composite resin to glass-infiltrated alumina composite conditioned with Er,Cr:YSGG laser
- 25 August 2010
- journal article
- research article
- Published by Springer Nature in Lasers in Medical Science
- Vol. 27 (1) , 7-14
Abstract
Tribochemical silica-coating is the recommended conditioning method for improving glass-infiltrated alumina composite adhesion to resin cement. High-intensity lasers have been considered as an alternative for this purpose. This study evaluated the morphological effects of Er,Cr:YSGG laser irradiation on aluminous ceramic, and verified the microtensile bond strength of composite resin to ceramic following silica coating or laser irradiation. In-Ceram Alumina ceramic blocks were polished, submitted to airborne particle abrasion (110 μm Al2O3), and conditioned with: (CG) tribochemical silica coating (110 μm SiO2) + silanization (control group); (L1-L10) Er,Cr:YSGG laser (2.78 μm, 20 Hz, 0.5 to 5.0 W) + silanization. Composite resin blocks were cemented to the ceramic blocks with resin cement. These sets were stored in 37°C distilled water (24 h), embedded in acrylic resin, and sectioned to produce bar specimens that were submitted to microtensile testing. Bond strength values (MPa) were statistically analyzed (α ≤0.05), and failure modes were determined. Additional ceramic blocks were conditioned for qualitative analysis of the topography under SEM. There were no significant differences among silicatization and laser treatments (p > 0.05). Microtensile bond strength ranged from 19.2 to 27.9 MPa, and coefficients of variation ranged from 30 to 55%. Mixed failure of adhesive interface was predominant in all groups (75–96%). No chromatic alteration, cracks or melting were observed after laser irradiation with all parameters tested. Surface conditioning of glass-infiltrated alumina composite with Er,Cr:YSGG laser should be considered an innovative alternative for promoting adhesion of ceramics to resin cement, since it resulted in similar bond strength values compared to the tribochemical treatment.Keywords
This publication has 51 references indexed in Scilit:
- Bond Strength of Resin Cements to a Zirconia Ceramic with Different Surface TreatmentsOperative Dentistry, 2009
- Surface Modification of In-Ceram Zirconia Ceramic by Nd:YAG Laser, Rocatec System, or Aluminum Oxide Sandblasting and Its Bond Strength to a Resin CementPhotomedicine and Laser Surgery, 2008
- Effect of Er:YAG, CO2 and diode laser irradiation on surface properties of zirconia endosseous dental implantsLasers in Surgery and Medicine, 2008
- The Influence of Internal Surface Treatments on Tensile Bond Strength for Two Ceramic SystemsOperative Dentistry, 2007
- Effect of Feldspathic Ceramic Surface Treatments on Bond Strength to Resin CementPhotomedicine and Laser Surgery, 2007
- Bond Strengths of All-Ceramics: Acid vs Laser EtchingOperative Dentistry, 2007
- Influence of the water content in dental enamel and dentin on ablation with erbium YAG and erbium YSGG lasersJournal of Biomedical Optics, 2006
- Effects of the Nd:YAG laser, air-abrasion, and acid-etchant on filling materialsJournal of Oral Rehabilitation, 2006
- Porcelain surface treatment by laser for bracket-porcelain bondingAmerican Journal of Orthodontics and Dentofacial Orthopedics, 2005
- Bactericidal effect of different laser systems in the deep layers of dentinLasers in Surgery and Medicine, 2004