Electroless Ni Plating to Compensate for Bump Height Variation in Cu–Cu 3-D Packaging
Authors:
- 2 March 2012
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Components, Packaging and Manufacturing Technology
- Vol. 2 (6) , 964-970
Abstract
The feasibility of electroless Ni plating to compensate the Cu bump height variation in Cu-Cu 3-D packaging was investigated. After fabricating Cu pillar bump and Cu micro-stud structure on the top and bottom chips, respectively, Cu-Cu thermocompression bonding and then electroless Ni plating were sequentially carried out and evaluated using dies shear force, daisy chain resistance, and microstructure. It is found that thermocompression bonding parameter optimization and Ar plasma surface cleaning increased the Cu-Cu bond strength. The electroless Ni plating can compensate for the bump height variation of 1.9 μm in a chip with filling the gap between the Cu-pillar bump and Cu-micro-stud structure. In addition, the electroless plated Ni reduced the daisy chain resistance with the increase of the contact area. The resistance of bump daisy chains after electroless Ni plating was measured to be about 15% lower than that obtained after Cu-Cu thermocompression bonding.Keywords
This publication has 19 references indexed in Scilit:
- Cu/Sn microbumps interconnect for 3D TSV chip stacking2010
- Investigations of Cu bond structures and demonstration of a wafer-level 3D integration scheme with W TSVs2010
- Plasma cleaning on bond pad surfaces for gold wire bonding2009
- 32nm node BEOL integration with an extreme low-k porous SiOCH dielectric k=2.3Microelectronic Engineering, 2009
- 3D chip stacking with C4 technologyIBM Journal of Research and Development, 2008
- Cu pillar bumps as a lead-free drop-in replacement for solder-bumped, flip-chip interconnects2008
- Bonding parameters of blanket copper wafer bondingJournal of Electronic Materials, 2006
- Reliability improvements in solder bump processing for flip chips2002
- Multiple-chip precise self-aligned assembly for hybrid integrated optical modules using Au-Sn solder bumpsIEEE Transactions on Advanced Packaging, 2001
- Plasma processingIEEE Transactions on Plasma Science, 1994