Influence of initial polymer concentration in solution and weight‐average molecular weight on the drawing behavior of polyethylenes
Author:
- 1 August 1990
- journal article
- research article
- Published by Wiley in Journal of Polymer Science Part B: Polymer Physics
- Vol. 28 (9) , 1475-1482
Abstract
The influence of initial polymer concentration in solution (c), weight‐average molecular weight (Mω), and drawing temperature on the solid‐state drawing behavior of linear polyethylenes was investigated. Optimum conditions, with respect to maximum attainable draw ratio, are observed in isothermal drawing experiments. Moreover, it is shown that high maximum attainable draw ratios can also be obtained upon multistage drawing of UHMW‐PE (ultrahigh‐molecular‐weight polyethylene, Mω > 106 g/mol) gel films cast from concentrated solutions. The high maximum attainable draw ratio in combination with the high molecular weight (Mω > 106 g/mol) and polymer concentration (c = 10% w/v) is of particular interest because it results in tapes or fibers with a high Young's modulus (100 GPa) and tensile strength (2.5–3.5 GPa). It is also shown that the maximum attainable draw ratio of polyethylenes scales with the Bueche parameter (c · Mω) to the −0.5 power. This experimental observation indicates that intermolecular interactions not only dominate the rheological properties of polyethylene melts and concentrated solutions, but also strongly influence the solid‐state drawing behavior of linear polyethylenes.Keywords
This publication has 16 references indexed in Scilit:
- Speciality products based on commodity polymersPolymer, 1985
- Tensile strength of highly oriented polyethylene. II. Effect of molecular weight distributionJournal of Polymer Science: Polymer Physics Edition, 1982
- Tensile strength of highly oriented polyethyleneJournal of Polymer Science: Polymer Physics Edition, 1981
- Ultra-high strength polyethylene filaments by solution spinning/drawing. 3. Influence of drawing temperaturePolymer, 1980
- The drawing behavior of linear polyethylene. I. Rate of drawing as a function of polymer molecular weight and initial thermal treatmentJournal of Polymer Science: Polymer Physics Edition, 1976
- Effect of molecular weight on the morphology and drawing behaviour of melt crystallized linear polyethylenePolymer, 1975
- Ultra‐high‐modulus linear polyethylene through controlled molecular weight and drawingPolymer Engineering & Science, 1975
- Preparation of ultra-high modulus linear polyethylenes; effect of molecular weight and molecular weight distribution on drawing behaviour and mechanical propertiesPolymer, 1974
- Newtonian Viscosity-Molecular Weight Relationship for Concentrated Solutions of Monodisperse PolystyreneMacromolecules, 1969
- Viscosity—Molecular Weight Dependence for Short Chain PolystyrenesThe Journal of Chemical Physics, 1964