Dispersing Properties of Copolymers Able to Act as Binders
Authors:
- Ben RomdhaneBRBen Romdhane
- M. RamziMRM. Ramzi
- Samir BakloutiSBSamir Baklouti
- Jamel BouazizJBJamel Bouaziz
- Thierry ChartierTCThierry Chartier
- Jean‐François BaumardJBJean‐François Baumard
- 13 September 2005
- journal article
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 89 (1) , 104-109
Abstract
Macromolecules, containing both charged groups (COO− and SO3−), in order to ensure powder dispersion, and neutral groups (vinyl alcohol and ethyl hydroxyl acrylate), in order to obtain enough strength in the green parts, were synthesized to be used in the dry pressing process. The evaluation and the comparison of the capacity of these synthesized copolymers with disperse alumina particles in aqueous media are considered in this paper. Both COO− and SO3− ionized groups are responsible for strong adsorption onto alumina surface and can promote sufficient electrostatic repulsive forces to achieve a good state of dispersion. The role of the copolymers in the stabilization of alumina suspensions was found to be greatly affected by the nature and by the fraction of groups in the macromolecular chains. A low concentration of copolymers (0.5 wt% on alumina basis) containing 35% of carboxylic groups and 65% of vinyl alcohol groups (PV35) or containing 55% of carboxylic groups and 45% of hydroxy ethyl acrylate groups (EH2A55) leads to stable alumina suspensions with a low viscosity similar to that obtained with a classical ammonium polymethacrylate (between 10 and 20 mPa·s for 27 vol% alumina suspensions). Copolymers containing sulfonate groups are less efficient.Keywords
This publication has 28 references indexed in Scilit:
- Polymer/Surfactant Interaction: Interfacial AspectsJournal of Colloid and Interface Science, 2002
- Aqueous tape casting of silicon nitrideJournal of the European Ceramic Society, 2002
- Factorial design of experiments on the effect of surface charges on stability of aqueous colloidal ceramic suspensionColloids and Surfaces A: Physicochemical and Engineering Aspects, 2002
- Dispersion of alumina-coated TiO2 particles by adsorption of sodium polyacrylateColloids and Surfaces A: Physicochemical and Engineering Aspects, 2001
- Stabilizing ceramic suspensions using anionic polyelectrolytes: adsorption kinetics and interparticle forcesActa Materialia, 2000
- Surface and electrokinetic properties of Y-TZP suspensions stabilized by polyelectrolytesCeramics International, 2000
- Interaction of binders with dispersant stabilised alumina suspensionsColloids and Surfaces A: Physicochemical and Engineering Aspects, 2000
- Can charged (block co)polymers act as stabilisers and flocculants of oxides?Colloids and Surfaces A: Physicochemical and Engineering Aspects, 1996
- Viscosity and Yield Stress of Alumina Slurries Containing Large Concentrations of ElectrolyteJournal of the American Ceramic Society, 1994
- Adsorption of polyacrylamide on oxide mineralsLangmuir, 1989