Workload balancing capability of pull systems in MTO production
- 15 April 2009
- journal article
- research article
- Published by Taylor & Francis in International Journal of Production Research
- Vol. 48 (8) , 2345-2360
Abstract
Pull systems focusing on throughput time control and applicable in situations with high variety and customisation are scarce. This paper compares three unit-based pull systems that can cope with such situations: POLCA, CONWIP and m-CONWIP. These systems control the shop floor throughput time of orders by limiting the number of orders on the shop floor. However, their effectiveness in terms of reducing total throughput time is questioned. Theory states that an improvement in the average total throughput time will be due to the workload balancing capability of a pull system, but that many pull systems lack this capability. This paper shows that this workload balancing capability exists for POLCA and m-CONWIP, but not for CONWIP. The magnitude of the effect differs strongly, depending on the configuration of the system, the order arrival pattern and the variability of the processing time of the orders.Keywords
This publication has 12 references indexed in Scilit:
- Generic POLCA—A production and materials flow control mechanism for quick response manufacturingInternational Journal of Production Economics, 2006
- A review of production planning and control: the applicability of key concepts to the make-to-order industryInternational Journal of Production Research, 2005
- To Pull or Not to Pull: What Is the Question?Manufacturing & Service Operations Management, 2004
- The CONWIP production control system: Review and research issuesProduction Planning & Control, 2003
- Workload control in job shops: an introduction to the special issueProduction Planning & Control, 2002
- The workload control concept: theory and practical extensions of Load Oriented Order ReleaseProduction Planning & Control, 2002
- The performance of workload control concepts in job shops: Improving the release methodInternational Journal of Production Economics, 1998
- CONWIP: a pull alternative to kanbanInternational Journal of Production Research, 1990
- Load‐limited order release in job shop scheduling systemsJournal of Operations Management, 1988
- A Proof for the Queuing Formula: L = λWOperations Research, 1961