Microwave‐assisted hydrothermal liquefaction of lignin for the preparation of phenolic formaldehyde adhesive
- 9 November 2016
- journal article
- research article
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 134 (10)
Abstract
This study aimed to produce phenolic formaldehyde (PF) adhesives using the liquefaction product of bagasse lignin (LPBL) as a partial substitute for petroleum‐based phenol. Lignin was extracted from bagasse using 93% acetic acid solution and was rapidly degraded in hot‐compressed water by microwave heating using oxalic acid as catalyst. The liquefaction yield reached 78.69% under the optimal reaction condition. Gas chromatography–mass spectrometry (GC/MS) analysis showed that the main chemical compounds of the liquefaction product included mono‐substituted and bis‐substituted phenols, such as 2,6‐dimethoxyphenol, 4‐hydroxybenzaldehyde, and so on. The LPBL was employed to replace a portion of phenol at varying ratios from 0 to 20 wt % in the preparation of PF adhesives. The molecular weight, viscosity, and adhesive strength of LPBL‐PF adhesives were found to be lower than those of pure PF adhesives. With the phenol replaced by LPBL up to 20%, the viscosity and adhesive strength of the resin were 4.046 Pa s and 1.017 MPa, respectively. © 2016 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2017, 134, 44510.Keywords
Funding Information
- National High Technology Research and Development Program
- of China (2013AA050701)
- International S&T Cooperation Program of China (2011DFA61910)
- Guangxi International Science and Technology Cooperation Project (15104001-5)
- Guangxi Natural Science Foundation (2015GXNSFBA139022)
- Project of Development of Science and Technology of Nanning (20161020)
- Scientific Research Foundation of Guangxi Academy of Sciences (13YJ22SW04, 15YJ22SW04)
This publication has 39 references indexed in Scilit:
- Hydrothermal degradation of alkali lignin to bio-phenolic compounds in sub/supercritical ethanol and water–ethanol co-solventPolymer Degradation and Stability, 2012
- Pretreatment by ultra-high pressure explosion with homogenizer facilitates cellulase digestion of sugarcane bagassesBioresource Technology, 2010
- Preparation and characterization of phenol–formaldehyde adhesives modified with enzymatic hydrolysis ligninBioresource Technology, 2010
- Production, characterization and evaluation of methylcellulose from sugarcane bagasse for applications as viscosity enhancing admixture for cement based materialCarbohydrate Polymers, 2009
- Agricultural palm oil tree residues as raw material for cellulose, lignin and hemicelluloses production by ethylene glycol pulping processChemical Engineering Journal, 2009
- Novolak PF resins prepared from phenol liquefied Cryptomeria japonica and used in manufacturing moldingsBioresource Technology, 2008
- Lignins for phenol replacement in novolac‐type phenolic formulations. II. Flexural and compressive mechanical propertiesJournal of Applied Polymer Science, 2007
- Physico-chemical characterization of lignins from different sources for use in phenol–formaldehyde resin synthesisBioresource Technology, 2007
- Effect of Water Density on the Gasification of Lignin with Magnesium Oxide Supported Nickel Catalysts in Supercritical WaterIndustrial & Engineering Chemistry Research, 2005
- Relative reactivity of alkaline extracts of Taiwanese biomass residues toward formaldehydeBiomass and Bioenergy, 2001