Graphene-Reinforced PE-RT Nanocomposites for Flexible Pipeline Barriers: Structure–Property–Performance and Aging
Open Access
- 14 October 2026
- journal article
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 11 (42) , 65747-65764
Abstract
Polyethylene of raised temperature resistance (PE-RT Type II) is the preferred material for barrier layers in offshore flexible risers, yet its CO2 permeability and long-term stability under hydrocarbon exposure remain critical performance gaps. Here, PE-RT nanocomposites reinforced with four graphene-based fillers─graphene oxide (GO), reduced graphene oxide (rGO), vinyltrimethoxysilane-functionalized GO (GOS), and graphene nanoplatelets (GNP)─at 0.5–2.0 wt % were prepared by melt compounding and systematically characterized. Filler surface chemistry and structure were characterized by Fourier transform infrared spectroscopy (FTIR), X-ray diffraction (XRD), Raman spectroscopy, thermogravimetric analysis (TGA), and scanning electron microscopy coupled with energy-dispersive X-ray spectroscopy (SEM/EDS), revealing distinct structural and interfacial features among the graphene-based fillers. SEM provided qualitative information on filler morphology and microscale distribution, while Raman spectroscopy and XRD were used to characterize the structural features of the graphene-based fillers. Because nanoscale dispersion within the PE-RT matrix was not directly quantified by TEM, AFM, or other image-based methods, relationships between filler dispersion and functional performance are discussed as structure–property interpretations rather than direct measurements of nanoscale dispersion. GOS delivered the greatest CO2 barrier improvement, reducing the mean permeability by 56.5% at 1 wt % relative to neat PE-RT (2.13 ± 0.30 vs 4.90 ± 0.10 cm2 s–1 psi–1; Tukey HSD, p < 0.001). The Nielsen tortuosity model yielded an effective platelet aspect ratio of ≈570, consistent with efficient platelet-induced tortuosity. GNP exhibited the highest mean stiffness at 1 wt %, with an elastic modulus increase of approximately 50.8% relative to neat PE-RT. Six months of immersion aging in synthetic hydrocarbon oil (ISO 23936-1, 80 °C) produced formulation-dependent changes in thermal, surface, dimensional, and molar-mass-related properties. The graphene-containing nanocomposites showed lower swelling than neat PE-RT, while GOS exhibited comparatively stable GPC parameters over the aging period. These results demonstrate enhanced aging resistance, although the specific mechanisms responsible for this stabilization were not directly determined. GNP showed comparatively poorer CO2 barrier performance despite exhibiting the highest mean mechanical properties among the 1 wt % nanocomposites. These results establish quantitative structure–property–performance relationships and provide design guidelines for graphene-functionalized polyolefin barrier materials in demanding service environments.Keywords
Funding Information
- Conselho Nacional de Desenvolvimento Científico e Tecnológico (NA)
- Petrobras (NA)
- Fundação Carlos Chagas Filho de Amparo à Pesquisa do Estado do Rio de Janeiro (NA)
This publication has 57 references indexed in Scilit:
- Synergistic Effect of Surface Area and Filler Loading of Graphene Nanoplatelets on High‐Density Polyethylene for Advanced Gas Barrier ApplicationsJournal of Applied Polymer Science, 2026
- PE‐RT Grades for High‐Temperature Flexible Risers: Comparative Evaluation of Thermal, Mechanical, and Aging PerformanceJournal of Applied Polymer Science, 2025
- Poly(lactide) and Ni nanoparticles supported thermally reduced graphene oxide nanoarchitecture for magnetic stimuli‐responsive materialPolymer Composites, 2025
- Structural, optical and electrochemical properties of reduced graphene oxide-polyaniline composites for supercapacitor applicationsJournal of Materials Science: Materials in Electronics, 2024
- Different aspects of polymer films based on low‐density polyethylene using graphene as fillerJournal of Applied Polymer Science, 2023
- Investigation of chemical bonding and electronic network of rGO/PANI/PVA electrospun nanofiberPolymer Bulletin, 2020
- A review of the mechanical and thermal properties of graphene and its hybrid polymer nanocomposites for structural applicationsJournal of Materials Science, 2018
- Synthesis of high‐density polyethylene/rGO‐CNT‐Fe nanocomposites with outstanding magnetic and electrical propertiesJournal of Applied Polymer Science, 2017
- Thermal stability and thermal degradation kinetics (model-free kinetics) of nanocomposites based on poly (lactic acid)/graphene: the influence of functionalizationPolymer Bulletin, 2015
- Improving the thermal and mechanical properties of silicone polymer by incorporating functionalized graphene oxideJournal of Materials Science, 2013