Precipitation during γ-ε Phase Transformation in Biomedical Co-Cr-Mo Alloys Fabricated by Electron Beam Melting
Open Access
Abstract
We studied the precipitates that were induced during γ-ε phase transformation in biomedical Co-28Cr-6Mo (mass%) alloys that were fabricated by electron beam melting with carbon contents of 0.184 and 0.018 mass%. In the high-C as-built alloy, M23X6-type, π-phase (M3T2X-type), and η-phase (M6X-M12X-type) precipitates were observed (M and T: metallic elements, X: C and/or N). σ-phase (Co(Cr,Mo)), π-phase, and Co3Mo2Si-type precipitates were observed in the low-C as-built alloy. This is the first report that shows the presence and chemical composition of this precipitate, as the Co3Mo2Si-type precipitate has not been detected in biomedical Co-Cr-Mo alloys before. After aging in the ε-phase stability region, the high-C and low-C alloys both contained a single ε-phase matrix, and the amount of π-phase precipitates increased. Conversely, the amount of π-phase precipitates in both alloys decreased when a reverse transformation treatment was applied in the γ-phase stability region after aging. In the low-C alloy, the amount of Co3Mo2Si-type precipitates increased after reverse transformation treatment. These results indicate that the dissolution of π-phase precipitates and the formation of Co3Mo2Si-type precipitates during reverse transformation promote the formation of fine γ-phase grains at the precipitate/ε-phase matrix interface, because the formation and dissolution of these precipitates affect the γ-phase stability of the matrix.Keywords
Funding Information
- Japan Society for the Promotion of Science (JP 19K23580, JP 18H01718, JP 18H03834, JP 17H01329)
This publication has 31 references indexed in Scilit:
- Effect of solution heat treatment on microstructure and mechanical properties of laser powder bed fusion produced cobalt-28chromium-6molybdenumMaterials Science and Engineering: A, 2020
- Fatigue improvement of electron beam melting-fabricated biomedical Co–Cr–Mo alloy by accessible heat treatmentMaterials Research Letters, 2017
- Metallurgy of additive manufacturing: Examples from electron beam meltingAdditive Manufacturing, 2015
- Microstructures and mechanical properties of Co–29Cr–6Mo alloy fabricated by selective laser melting process for dental applicationsJournal of the Mechanical Behavior of Biomedical Materials, 2013
- Strain-induced martensitic transformation near twin boundaries in a biomedical Co–Cr–Mo alloy with negative stacking fault energyActa Materialia, 2013
- Electrochemical characterisation of biomedical alloys for surgical implants in simulated body fluidsCorrosion Science, 2008
- Significant Improvement in Mechanical Properties of Biomedical Co-Cr-Mo Alloys with Combination of N Addition and Cr-EnrichmentMATERIALS TRANSACTIONS, 2008
- Review of wear mechanisms in hip implants: Paper I – GeneralMaterials & Design (1980-2015), 2004
- Recent metallic materials for biomedical applicationsMetallurgical and Materials Transactions A, 2002
- Cast vs. wrought cobalt‐chromium surgical implant alloysJournal of Biomedical Materials Research, 1975