The A1 to L1 transformation in FePt and FeCuPt thin films: Determination of isothermal transformation kinetics from nonisothermal measurements
- 15 April 2006
- journal article
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 99 (8) , 08G901
Abstract
Time–temperature-transformation diagrams describing the A1 to L10 transformation in 1μm thick FePt and FeCuPt alloy films are constructed from data obtained using nonisothermal differential scanning calorimetry in conjunction with a limited number of isothermal anneals. For the FePt alloys, an increase in Pt content from 45.6 to 52.5 at.% results in a >300× increase in the annealing time needed to reach a fraction transformed of 0.95 at 300 °C. Using geometric corrections, the results are extended to 10 nm thick films, which are found to transform approximately five times more slowly than thicker films.Keywords
This publication has 8 references indexed in Scilit:
- Differential scanning calorimetry studies of the effect of Cu on the A1 to L10 transformation in FePt thin filmsScripta Materialia, 2005
- Calorimetric studies of the A1 to L1 transformation in binary FePt thin films with compositions in the range of 47.5–54.4at.% FeJournal of Applied Physics, 2004
- Phase transformation kinetics and self-patterning in misfitting thin filmsActa Materialia, 2003
- Evolution of stress with L1 ordering in FePt and FeCuPt thin filmsJournal of Applied Physics, 2003
- On the determination of nucleation and growth kinetics by calorimetryThermochimica Acta, 1996
- High anisotropy L1/sub 0/ thin films for longitudinal recordingIEEE Transactions on Magnetics, 1995
- Magnetic, transport, and structural properties of iron-platinum thin filmsIEEE Transactions on Magnetics, 1984
- Variation of peak temperature with heating rate in differential thermal analysisJournal of Research of the National Bureau of Standards, 1956