Static Performance of a Hydrostatic Thrust Foil Bearing for Large Scale Oil-Free Turbomachines
- 26 February 2021
- journal article
- research article
- Published by ASME International in Journal of Engineering for Gas Turbines and Power
- Vol. 143 (4)
Abstract
This work presents a novel design of a hydrostatic thrust foil bearing (HSTFB), with an outer diameter of 154 mm, along with simulation and test results up to a specific load capacity of 223 kPa (32.3 psi). This bearing has high load capacity, low power loss, and no friction/wear during startup and shutdown. In addition, the HSTFB allows for bidirectional operation. The paper also presents an advanced simulation model that adopts the exact locations of tangentially arranged bumps to a cylindrical two-dimensional plate model of the top foil. This method predicts top foil deflection with better accuracy than the traditional independent elastic foundation model, which distributes the bump locations over the nodal points in the cylindrical coordinates, and with less computational resources than the finite element method applied to the entire bumps/top foils. The presented HSTFB was designed for organic Rankine cycle (ORC) generators, but its performance was predicted and measured using air in this paper. The bearing static performance is compared analytically against the rigid counterpart and presented at different supply pressures, speeds, and minimum film thicknesses. Experimental verification is conducted at 10, 15, and 20 krpm. The measured load capacity and frictional loss agree well with the prediction. The measured film thickness also agrees with the prediction after the structural deflection of the thrust runner disk is compensated. Overall, the novel HSTFB demonstrates excellent static performance and good potential for the intended ORC generators and other large oil-free turbomachines.Keywords
This publication has 10 references indexed in Scilit:
- Effect of Circumferential Location of Radial Injection on Rotordynamic Performance of Hybrid Air Foil BearingsJournal of Engineering for Gas Turbines and Power, 2018
- Effect of Foil Geometry on the Static Performance of Thrust Foil BearingsJournal of Engineering for Gas Turbines and Power, 2018
- Imbalance Response and Stability Characteristics of a Rotor Supported by Hybrid Air Foil BearingsTribology Transactions, 2012
- Design of Three-Pad Hybrid Air Foil Bearing and Experimental Investigation on Static Performance at Zero Running SpeedJournal of Engineering for Gas Turbines and Power, 2010
- Hydrostatic air foil bearings: Analytical and experimental investigationTribology International, 2009
- Parametric Studies on Dynamic Performance of Hybrid Airfoil BearingJournal of Engineering for Gas Turbines and Power, 2008
- Theoretical considerations of static and dynamic characteristics of air foil thrust bearing with tilt and slip flowTribology International, 2008
- Performance of a Foil-Magnetic Hybrid BearingJournal of Engineering for Gas Turbines and Power, 2002
- On the Performance of Hybrid Foil-Magnetic BearingsJournal of Engineering for Gas Turbines and Power, 1999
- Analysis of Gas Lubricated Foil Thrust Bearings Using Coupled Finite Element and Finite Difference MethodsJournal of Tribology, 1999