Film Cooling Performance of Sharp Edged Diffuser Holes With Lateral Inclination
Authors:
- 1 July 2011
- journal article
- Published by Wiley in Journal of Turbomachinery
- Vol. 134 (4) , 041015
Abstract
An experimental study on film cooling performance of laterally inclined diffuser shaped cooling holes is presented. The measurements have been conducted on a flat plate with coolant ejected from a plenum. The film cooling effectiveness downstream of a row of four laidback fanshaped holes with sharp edged diffusers has been determined by means of infrared (IR) thermography. A variety of geometric parameters has been tested, including the inclination angle, the compound angle, the area ratio, and the pitch to diameter ratio. All tests have been performed over a wide range of engine typical blowing ratios (M=0.5–3.0). The hot gas Reynolds number and the coolant to hot gas density ratio have been kept constant close to engine realistic conditions. The results, presented in terms of contour plots of related adiabatic film cooling effectiveness as well as laterally averaged related values, clearly show the influences of the cooling hole geometry. Increasing the area ratio and the compound angle, in general, leads to higher values of the effectiveness, whereas steeper injection causes a reduction of the effectiveness.Keywords
This publication has 16 references indexed in Scilit:
- Effect of Geometry Variations on the Cooling Performance of Fan-Shaped Cooling Holes2008
- Effect of Hole Geometry on the Thermal Performance of Fan-Shaped Film Cooling HolesJournal of Turbomachinery, 2005
- A Review of Shaped Hole Turbine Film-Cooling TechnologyJournal of Heat Transfer, 2005
- Effect of Internal Coolant Crossflow on the Effectiveness of Shaped Film-Cooling HolesJournal of Turbomachinery, 2003
- Film Cooling Effectiveness Downstream of Compound and Fan-Shaped Holes2001
- FILM COOLING PERFORMANCE ON CURVED WALLS WITH COMPOUND ANGLE HOLE CONFIGURATIONAnnals of the New York Academy of Sciences, 2001
- Film Cooling From Shaped HolesJournal of Heat Transfer, 1999
- Film Cooling Effectiveness and Heat Transfer Coefficient Distributions Around Diffusion Shaped Holes1999
- Adiabatic Wall Effectiveness Measurements of Film-Cooling Holes With Expanded ExitsJournal of Turbomachinery, 1998
- Effects of hole geometry and density on three-dimensional film coolingInternational Journal of Heat and Mass Transfer, 1974