Effect of Mechanical Surface Treatment on the Static Strength of Adhesive Lap Joints
Authors:
- 20 February 2013
- journal article
- research article
- Published by Taylor & Francis in The Journal of Adhesion
- Vol. 89 (9) , 677-696
Abstract
This work deals with an experimental investigation on the effect of mechanical surface treatments of adhesive bonded joints. The behaviour of an adhesively bonded joint can be considered good if cohesive failure is achieved, while when interfacial failure occurs the performances are normally much worse. A key parameter which drives the failure type is the surface treatment applied to the adherends. This work analyzes, by means of a structured experimental campaign, which surface mechanical treatment gives the best performance. The design of the experimental approach used involves different materials, joint geometries, and surface treatments. The results are investigated in terms of force, energy, and stresses in the joints and the performance of the several mechanical treatments tested is assessed, showing that a simple correlation with the surface roughness is not sufficient to predict the best joint performances. The reliable results obtained prove that sandpapering or sandblasting the adherends gives a strong improvement in terms of performance and leads to a higher probability of cohesive failure.Keywords
This publication has 32 references indexed in Scilit:
- Effect of grooves on the strength of adhesively bonded jointsInternational Journal of Adhesion and Adhesives, 2010
- Effect of material, geometry, surface treatment and environment on the shear strength of single lap jointsInternational Journal of Adhesion and Adhesives, 2009
- Experimental and numerical analysis of single-lap joints for the automotive industryInternational Journal of Adhesion and Adhesives, 2009
- The cohesive mechanical properties of a toughened epoxy adhesive as a function of cure levelInternational Journal of Adhesion and Adhesives, 2007
- Warm water treatment of aluminum for adhesive bondingInternational Journal of Adhesion and Adhesives, 2003
- Surface energy, surface topography and adhesionInternational Journal of Adhesion and Adhesives, 2003
- Dry ice blasting as pretreatment of aluminum surfaces to improve the adhesive strength of aluminum bonding jointsInternational Journal of Adhesion and Adhesives, 2003
- Network structure in epoxy aluminium bonds after mechanical treatmentInternational Journal of Adhesion and Adhesives, 2002
- Boiling water and silane pre-treatment of aluminium alloys for durable adhesive bondingInternational Journal of Adhesion and Adhesives, 2000
- The effects of grit-blasting on surface properties for adhesionInternational Journal of Adhesion and Adhesives, 1999