Abstract
The object of research is the process of suppressing temperature drift at capacitance-to-frequency conversion interface based on two identical five-stage ring oscillators in 180 nm CMOS technology with a 1.8 V supply voltage, a node capacitive load of 2 pF, and a measurable capacitance range of 0–5 pF. Single-ended capacitance-to-frequency conversion interfaces based on ring oscillators have a high temperature coefficient of frequency. It reaches 2000–3000 ppm/°C. This causes a significant capacitance measurement error over the industrial temperature range from –40 to +125°C. This error exceeds the useful signal of a capacitive sensor by an order of magnitude. The problem addressed in this work is the lack of quantitative metric for evaluating temperature drift suppression efficiency in two-channel differential capacitance-to-frequency conversion interfaces based on ring oscillators in 180 nm CMOS technology. A dual ring oscillator architecture is proposed: the sensor and reference channels are built from identical subcircuits, their outputs are buffered and fed to a differential frequency unit, and the output signal is the normalized frequency difference ΔFnorm = (fsensor − fref)/fref. It is shown that the correlation of temperature drifts between the two channels (correlation coefficient r = 0.99998) yields a temperature drift rejection ratio of approximately 40–61 relative to the typical range of 2000–3000 ppm/°C; the temperature coefficient of frequency of the normalized signal is +49.5 ppm/°C, and at the balance point Csensor = Cload = 2 pF the rejection ratio tends to infinity. The combined power consumption of both channels is 1.04 mW at 27°C; the energy per oscillation cycle is stable at approximately 67 pJ across the entire temperature range. The transfer characteristic is monotonic over the 0–5 pF range. The results can be used for the design of interface circuits for capacitive microelectromechanical sensors of pressure, acceleration, and humidity operating under varying temperature conditions without active temperature compensation schemes. The normalized frequency output is directly compatible with digital frequency counters of standard microcontrollers, simplifying integration into measurement systems.