High power, high efficiency stacked mmWave Class-E-like power amplifiers in 45nm SOI CMOS
Authors:
- 1 September 2012
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 08865930,p. 1-4
Abstract
Stacking devices in CMOS power amplifiers (PAs) increases the achievable output voltage swing, thereby increasing the output power and efficiency, particularly at millimeter-wave frequencies. This work presents stacked CMOS PAs based on an improved Class-E design methodology, where device loss is explicitly accounted for in the analysis and design procedure. Design guidelines and fundamental limits on achievable performance are presented. Two fully-integrated 45GHz prototypes with 2 and 4 stacked devices have been fabricated in IBM's 45nm SOI CMOS technology. Measurement results yield a peak PAE of 34.6% for the 2-stacked PA with a saturated output power of 17.6 dBm, and a peak PAE of 19.4% for the 4-stacked PA with a saturated output power of 20.3 dBm. The former represents the highest PAE reported for CMOS mmWave PAs, and the latter represents the highest output power achieved from a CMOS mmWave PA. The paper also describes the modeling of active and passive devices for mmWave CMOS PAs for good model-hardware correlation.Keywords
This publication has 11 references indexed in Scilit:
- 215GHz CMOS signal source based on a Maximum Gain Ring Oscillator topology2012
- An improved analysis and design methodology for RF Class-E power amplifiers with finite DC-feed inductance and switch On-resistance2012
- A 60GHz outphasing transmitter in 40nm CMOS with 15.6dBm output power2012
- A Q-Band Amplifier Implemented with Stacked 45-nm CMOS FETs2011
- A Charging Acceleration Technique for Highly Efficient Cascode Class-E CMOS Power AmplifiersIEEE Journal of Solid-State Circuits, 2010
- A 60 GHz Power Amplifier With 14.5 dBm Saturation Power and 25% Peak PAE in CMOS 65 nm SOIIEEE Journal of Solid-State Circuits, 2010
- A high-gain 60GHz power amplifier with 20dBm output power in 90nm CMOS2010
- RF power potential of 45 nm CMOS technology2010
- Analysis of Reliability and Power Efficiency in Cascode Class-E PAsIEEE Journal of Solid-State Circuits, 2006
- Class E-A new class of high-efficiency tuned single-ended switching power amplifiersIEEE Journal of Solid-State Circuits, 1975