Effect of grit‐blasting parameters on the surface roughness and adhesion strength of sprayed coating
- 2 February 2010
- journal article
- research article
- Published by Wiley in Surface and Interface Analysis
- Vol. 42 (6-7) , 551-554
Abstract
Surface preparation is very important in adhesive bonding of spray coatings to the surface of a work piece. The common practice is grit blasting of the surface before subjecting it to the spray coating process. In this study, grit blasting of an AISI 4130 steel (of different heat treatments) with Al 2 O 3 particles was studied and the mean roughnesses (Ra), of the grit‐blasted surfaces were then measured. The results show that variations of working distance, air pressure and blasting time significantly affect the resultant surface roughness. The results also show that a 90° blasting angle gives slightly higher Ra but a significantly higher amount of grit residue, in comparison with the results obtained for a blasting angle of 45° . After grit blasting, the specimens were plasma spray coated with 80% ZrO 2 20% Y 2 O 3 powder. The adhesive strength of the coating to the substrate was then measured according to the ASTM C633 standard. The results show that for a certain base metal, the adhesive strength is directly related to the surface roughness and hardness of the base material. Copyright © 2010 John Wiley & Sons, Ltd.Keywords
This publication has 5 references indexed in Scilit:
- Effect of Grit-Blasting on Substrate Roughness and Coating AdhesionJournal of Thermal Spray Technology, 2006
- Effect of grit blasting of substrate on the corrosion behaviour of plasma-sprayed Al2O3 coatingsSurface and Coatings Technology, 1999
- Waterjet roughened surface analysis and bond strengthSurface and Coatings Technology, 1996
- Surface roughening of metallic substrates by high pressure pure waterjetSurface and Coatings Technology, 1995
- A review of adhesion test methods for thin hard coatingsJournal of Vacuum Science & Technology A, 1986