Pattern matching for variation-source identification in manufacturing processes in the presence of unstructured noise
- 23 February 2007
- journal article
- research article
- Published by Taylor & Francis in IIE Transactions
- Vol. 39 (3) , 251-263
Abstract
Variation-source identification has received considerable attention from the manufacturing quality improvement community. One widely used method is based on a pattern matching procedure, which identifies process faults by comparing the fault symptom, which is the principal eigenvector of the covariance matrix of the quality measurement, with fault signatures. The presence of unstructured noise as well as the uncertainty due to sampling will cause the direction of the fault symptom to deviate from the corresponding fault signature. The influences of these two effects on pattern matching procedures have previously been studied separately, by assuming either the absence of unstructured noise or the availability of large samples. This paper developes a robust pattern matching procedure that considers both effects simultaneously. Using a machining process as an illustrative example, the paper demonstrates that previous pattern matching procedures can have a remarkably low identification capability when the assumptions are not strictly satisfied. By contrast, our proposed method is more robust, maintaining a good identification probability, and would be a preferable tool for root-cause identification in manufacturing quality improvement.Keywords
This publication has 14 references indexed in Scilit:
- A Comparison of Process Variation Estimators for In-Process Dimensional Measurements and ControlJournal of Dynamic Systems, Measurement, and Control, 2004
- Fault Diagnosis of Multistage Manufacturing Processes by Using State Space ApproachJournal of Manufacturing Science and Engineering, 2002
- Diagnosability Analysis of Multi-Station Manufacturing ProcessesJournal of Dynamic Systems, Measurement, and Control, 2001
- A Factor-Analysis Method for Diagnosing Variability in Mulitvariate Manufacturing ProcessesTechnometrics, 2001
- State Space Modeling of Sheet Metal Assembly for Dimensional ControlJournal of Manufacturing Science and Engineering, 1999
- Dimensional Fault Diagnosis for Compliant Beam Structure AssembliesJournal of Manufacturing Science and Engineering, 1999
- Diagnosis of Multiple Fixture Faults in Panel AssemblyJournal of Manufacturing Science and Engineering, 1998
- Computational method for diagnosis of variation-related assembly problemsInternational Journal of Production Research, 1998
- Fixture Failure Diagnosis for Autobody Assembly Using Pattern RecognitionJournal of Engineering for Industry, 1996
- Aspects of Multivariate Statistical Theory1982