Quenching residual stress distributions in aluminum alloy plates with different dimensions
Authors:
- 6 September 2016
- journal article
- research article
- Published by Wiley in Rare Metals
- Vol. 38 (11) , 1051-1061
Abstract
Finite element method (FEM) simulations were employed to investigate the quenching residual stress distributions of 7085 aluminum alloy plates. The effect of dimensional variation on the quenching residual stress distributions was studied and discussed by using models with different dimensions (length, width, and thickness). The accuracy and efficiency of the models were verified by other numerical examples. The order of the dimension effects on the quenching residual stress distributions is: thickness > width = length. The maximum tensile stress and compressive stress increase from 33 to 190 and 39 to 270 MPa, respectively, as the thickness increases from 30 to 150 mm. The ultimate maximum tensile stress (about 190 MPa) is equivalent to half of the quenching yield strength at 20 °C, while the ultimate maximum compressive stress (about 300 MPa) is equivalent to 80 % of the quenching yield strength at 20 °C. There are stress fluctuations at the edge of the large plate both in rolling and in transverse directions. The ratio of the fluctuation region along the rolling direction and transverse direction increases as the thickness increases, while it decreases as the length or width increases. The actual length of the fluctuation region is almost a constant value for the plates with a thickness of 115 mm (about 500 mm in length and 300 mm in width).Keywords
Funding Information
- National Key Research and Development Program of China (2012CB619504)
- National Natural Science Foundation of China (51274046)
- National Basic Research of China (No. 2012CB619504)
- National Natural Science Foundation of China (No. 51274046)
This publication has 20 references indexed in Scilit:
- The influence of quench sensitivity on residual stresses in the aluminium alloys 7010 and 7075Materials Characterization, 2012
- Neutron diffraction measurements of time-dependent residual stresses generated by severe thermomechanical deformationScripta Materialia, 2009
- Residual stress measurements in a thick, dissimilar aluminum alloy friction stir weldActa Materialia, 2006
- Prediction of residual stresses in quenched aluminum blocks and their reduction through cold working processesJournal of Materials Processing Technology, 2006
- Uncertainty, Model Error, and Order Selection for Series-Expanded, Residual-Stress Inverse SolutionsJournal of Engineering Materials and Technology, 2005
- Effect of precipitation during quenching on the mechanical properties of the aluminium alloy 7010 in the W-temperJournal of Materials Processing Technology, 2004
- Quench sensitivity and tensile property inhomogeneity in 7010 forgingsJournal of Materials Processing Technology, 2001
- Residual Stress Measurement by Successive Extension of a Slot: The Crack Compliance MethodApplied Mechanics Reviews, 1999
- Study of through-thickness residual stress by numerical and experimental techniquesThe Journal of Strain Analysis for Engineering Design, 1998
- Determination of Residual Stress Profile Using a Strain Gage TechniqueJournal of the American Ceramic Society, 1990