In this research, a novel methodology was developed to study corrosion under aqueous electrolyte drops ranging in diameter from 20-1000 mm, the most common drop sizes found in coastal marine environments. The objective of this work was to examine the relationship between drop size and corrosion attack of bare low carbon steel under simulated atmospheric marine conditions. A drop-on-demand inkjet printer was custom built by coupling a commercial jetting device with a programmable two-axis stage. Singular droplets of sodium chloride (6.2 M NaCl in H2O and 8.7 mM in ethanol) were deposited on polished 1010 steel coupons and then exposed to a 75% relative humidity environment for 24 hours. It was found that, in general, the volume loss increased with drop diameter according to a power law. Corrosion always occurred under drops greater than 150 μm in diameter, but was not consistently observed under drops in the 20-100 mm range. The fraction of drops that showed no corrosion increased with decreasing drop size below 100 μm. However, drops smaller than 100 μm that caused corrosion were found to have the greatest volume loss compared to their salt loading density. Therefore, the manner and geometry in which salt is deposited onto a low carbon steel surface, along with the mode of attack, will significantly affect corrosion loss. From a technical standpoint, these results suggest that service life prediction approaches, including accelerated testing, will more accurately simulate natural atmospheres if electrolyte geometry is taken into account for these materials.