Control of unsteadiness of a shock wave/turbulent boundary layer interaction by using a pulsed-plasma-jet actuator
Authors:
Top Cited Papers
- 1 July 2012
- journal article
- conference paper
- Published by AIP Publishing in Physics of Fluids
- Vol. 24 (7) , 076101
Abstract
A pulsed-plasma jet actuator is used to control the unsteady motion of the separation shock of a shock wave/boundary layer interaction formed by a compression ramp in a Mach 3 flow. The actuator is based on a plasma-generated synthetic jet and is configured as an array of three jets that can be injected normal to the cross-flow, pitched, or pitched and skewed. The typical peak jet exit velocity of the actuators is about 300 m/s and the pulsing frequencies are a few kilohertz. A study of the interaction between the pulsed-plasma jets and the shock/boundary layer interaction was performed in a time-resolved manner using 10 kHz schlieren imaging. When the actuator, pulsed at StL ≈ 0.04 (f = 2 kHz), was injected into the upstream boundary layer, the separation shock responded to the plasma jet by executing a rapid upstream motion followed by a gradual downstream recovery motion. Schlieren movies of the interaction showed that the separation shock unsteadiness was locked to the pulsing frequency of the actuator, with amplitude of about one boundary layer thickness. Wall-pressure measurements made under the intermittent region showed about a 30% decrease in the overall magnitude of the pressure fluctuations in the low-frequency band associated with unsteady large-scale motion of the separated flow. Furthermore, by increasing the pulsing frequency to 3.3 kHz, the amplitude of the separation shock oscillation was reduced to less than half the boundary layer thickness. Investigation into the effect of the actuator location on the shock wave/boundary layer interaction (SWBLI) showed qualitatively and quantitatively that the actuator placed upstream of the separation shock caused significant modification to the SWBLI unsteadiness, whereas injection from inside the separation bubble did not cause a noticeable effect.Keywords
This publication has 17 references indexed in Scilit:
- Control of a Shock/Boundary-Layer Interaction by Using a Pulsed-Plasma Jet ActuatorAIAA Journal, 2012
- Effect of air jet vortex generators on a shock wave boundary layer interactionExperiments in Fluids, 2010
- Characterization of a High-Frequency Pulsed-Plasma Jet Actuator for Supersonic Flow ControlAIAA Journal, 2010
- Effects of plasma aerodynamic actuation on oblique shock wave in a cold supersonic flowJournal of Physics D: Applied Physics, 2009
- Space and time organisation of a shock wave/turbulent boundary layer interactionAerospace Science and Technology, 2005
- Fifty Years of Shock-Wave/Boundary-Layer Interaction Research: What Next?AIAA Journal, 2001
- Effect of periodic blowing on attached and separated supersonic turbulent boundary layersAIAA Journal, 1991
- Shock-wave-turbulent-boundary-layer interaction and its control: A survey of recent developmentsSādhanā, 1988
- Injection slot location for boundary-layer control in shock-induced separationJournal of Aircraft, 1983
- Fluctuating Wall Pressure under a Separated Supersonic FlowThe Journal of the Acoustical Society of America, 1964