Towards a simple and reliable method for calculating uplift capacity of plate anchors in sand
Authors:
- 1 September 2021
- journal article
- research article
- Published by Canadian Science Publishing in Canadian Geotechnical Journal
- Vol. 58 (9) , 1314-1333
Abstract
This paper investigates the uplift capacity of horizontal plate anchors in sand through finite element analyses and centrifuge experiments. The finite element simulations adopt a sophisticated bounding surface plasticity model that accounts for stress- and density-dependent behaviour, as well as loading- and fabric-related anisotropic effects in sands. Failure mechanisms at peak anchor capacity show that failure occurs progressively, with a marked decrease in mobilised friction angle within the shear bands close to the anchor edge. Numerical simulations of a large set of centrifuge experiments on rectangular, strip, and circular plates at different relative densities and stress levels are in good agreement for dense conditions, but perform more poorly for loose conditions due mainly to the open cone yield surface in the bounding surface model. Equivalent comparisons with current limit equilibrium methods highlight the challenges in direct application of element-level strength equations. Finally, the paper proposes a modified limit equilibrium solution based on a “rigid-block” failure mechanism extending to the soil surface, but with anchor factors that encompass the results from the finite element simulations. The modified solution provides a higher level of agreement with results from a large database of plate and pipeline test data than existing limit equilibrium methods.Keywords
This publication has 41 references indexed in Scilit:
- Effect of anchor width on pullout capacity of strip anchors in sandCanadian Geotechnical Journal, 2011
- A comparison of the bearing capacity of flat and conical circular foundations on sandGéotechnique, 2008
- The ultimate pullout capacity of anchors in frictional soilsCanadian Geotechnical Journal, 2006
- Three-dimensional lower-bound solutions for the stability of plate anchors in sandGéotechnique, 2006
- Experimental investigation of the uplift behaviour of circular plate anchors embedded in sandCanadian Geotechnical Journal, 2002
- A Dual Interface Apparatus for Testing Unrestricted Friction of Soil Along Solid SurfacesGeotechnical Testing Journal, 1995
- Uplift Resistance of Buried Pipelines in SandSoils and Foundations, 1994
- Scale Effect in Anchor Pullout Test by Centrifugal TechniqueSoils and Foundations, 1988
- Discussion: The strength and dilatancy of sandsGéotechnique, 1987
- The behaviour of anchor plates in sandGéotechnique, 1982