Wire Cable Failures in Climbing Anchor Chocks
Authors:
- 15 September 2007
- journal article
- Published by Trans Tech Publications, Ltd. in Key Engineering Materials
- Vol. 348-349, 165-168
Abstract
Anchor chocks are used in the sport of rock climbing for providing secure attachment to a rock face. They are used at regular intervals and must be light weight (since many are carried) and also sufficiently strong to withstand an impact force should a climber fall from a height. In chock design, steel wire cable is widely used for connecting the nut component, which is wedged into a rock crevice, to the free end which attaches, via a karabiner link, to the safety rope. However, the wire cable is vulnerable to failure as it can fray with use at exposed ends - especially when folded into a loop using tight bends. Also, the ferrule end connections are considered a potential design weakness. In a research programme tests have been carried out on new and also some well used anchor chocks and has revealed very different, and some unpredicted, failure modes – depending on the state of the wire rope and whether the applied load at failure was static or impact. This paper presents the results of test failures for a range of chocks and discusses the benefits of using single lengths of wire cable with suitably swaged end ferrules.Keywords
This publication has 5 references indexed in Scilit:
- The safety of rock climbing protection devices under falling loadsEngineering Failure Analysis, 2007
- An Estimation of the Load Rate Imparted to a Climbing Anchor During Fall Arrest2006
- Synopsis of Climbing — Instrumentation and Testing of Equipment2006
- Experimental and theoretical simulations of climbing fallsSports Engineering, 1999
- The development of equipment to reduce risk in rock climbingSports Engineering, 1998