Optimized MALDI-TOF MS Strategy for Characterizing Polymers
Open Access
- 24 June 2021
- journal article
- research article
- Published by Frontiers Media SA in Frontiers in Chemistry
- Vol. 9
Abstract
In recent years, matrix-assisted laser desorption/ionization time-of-flight mass spectrometry (MALDI-TOF MS) plays an essential role in the analysis of polymers. To acquire a more reliable strategy for polymer profiling, we characterized four representative polymers including polyethylene glycol 6000, polyvinylpyrrolidone K12, polymer polyol KPOP-5040, and polyether polyol DL-4000. The preparation methods of these four polymer samples have been optimized from six aspects, including matrix, cationization reagent, solvent, mixing ratio of cationization reagent to polymer, mixing ratio of matrix to polymer, and laser intensity. After investigating the effects of seven commonly used matrices on the ionization efficiency of four polymers, trans-2-[3-(4-tert-butylphenyl)-2-methyl-2-propenylidene] malononitrile (DCTB) was found to be the only matrix suitable for the analysis of all the four polymers. Our experimental results suggested that different polymers showed a certain preference for different cationization reagents. For example, the polymer polyol KPOP-5040 was suitable for sodium iodide as the cationization reagent, while polyvinylpyrrolidone K12 was more suitable for silver trifluoroacetate (AgTFA). For the choice of solvent, tetrahydrofuran is a reagent with rapid evaporation and a wide range of dissolution which can achieve the best results for the analysis of four polymers. The optimized method was successfully applied to the identification of DSPE-PEG-NH2 with different polymerized degrees. This MALDI-TOF strategy potentially provided the supplementary function through the polymer’s application in biomedical and visible probing.Keywords
This publication has 31 references indexed in Scilit:
- Solvent selection for matrix‐assisted laser desorption/ionization time‐of‐flight mass spectrometric analysis of synthetic polymers employing solubility parametersRapid Communications in Mass Spectrometry, 2010
- Detection limits of matrix‐assisted laser desorption/ionisation mass spectrometry coupled to chromatography – a new application of solvent‐free sample preparationRapid Communications in Mass Spectrometry, 2005
- Effect of sodium dodecyl sulfate micelles on peptide mass fingerprinting by matrix‐assisted laser desorption/ionization mass spectrometryRapid Communications in Mass Spectrometry, 2004
- Small angle neutron scattering measurements of synthetic polymer dispersions in matrix‐assisted laser desorption/ionization matrixesRapid Communications in Mass Spectrometry, 2002
- Characterization of Synthetic Polymers by MALDI-TOF/MS: Investigation into New Methods of Sample Target Preparation and Consequence on Mass Spectrum Finger PrintAnalytical Chemistry, 2000
- Confocal Fluorescence Microscopic Imaging for Investigating the Analyte Distribution in MALDI MatricesAnalytical Chemistry, 1996
- Influence of Matrix Solution Conditions on the MALDI-MS Analysis of Peptides and ProteinsAnalytical Chemistry, 1996
- Molecular weight distribution of poly(dimethylsiloxane) by combining matrix‐assisted laser desorption/ionization time‐of‐flight mass spectrometry with gel‐permeation chromatography fractionationRapid Communications in Mass Spectrometry, 1995
- Polymer molecular weight distribution: Results from matrix‐assisted laser desorption ionization compared with those from gel‐permeation chromatographyRapid Communications in Mass Spectrometry, 1995
- The analysis of water‐soluble polymers by matrix‐assisted laser desorption time‐of‐flight mass spectrometryJournal of Mass Spectrometry, 1992