Performance Investigation of a Large Turning Blade for Marine Gas Turbine Based on Experimental and Numerical Methods
Open Access
Abstract
Replacing the last-stage stator and the outlet guide vane of the low-pressure compressor of the marine gas turbine with a large turning blade can reduce the number of compressor blades and reduce the size and weight of marine gas turbines. At present, there are few studies on similar profiles, and it is necessary to verify the feasibility of this type of compressor profile with a large turning angle. The performance of this profile is investigated by combining experimental measurement with numerical simulation calculation. The analysis of the experimental and numerical results reveals that this profile has a large flow turning angle, a wide operating range, and low overall total pressure losses. The loss of the profile only suddenly increases at some large positive angles of attack due to the large separation of the suction surface. The results show that this profile can compress air and increase the turning ability at a low loss, and can play the role of both the original last-stage stator and the outlet guide vane. This research provides a reference for the design and analysis of marine gas turbines and guidance for the application of the blade to gas turbines in other fields.Keywords
Funding Information
- National Science and Technology Major Project of China (2017-II-0006-0020)
This publication has 18 references indexed in Scilit:
- Thermo-economic analysis and multi-objective optimization of a novel waste heat recovery system with a transcritical CO2 cycle for offshore gas turbine applicationEnergy Conversion and Management, 2018
- Performance analysis of the combined supercritical CO 2 recompression and regenerative cycle used in waste heat recovery of marine gas turbineEnergy Conversion and Management, 2017
- Simulation and experimental investigation of the wavy fin-and-tube intercoolerCase Studies in Thermal Engineering, 2016
- Investigation of parameters affecting exergy and emission performance of basic and intercooled gas turbine cyclesEnergy, 2015
- Adjoint-Based Optimization Method With Linearized SST Turbulence Model and a Frozen Gamma-Theta Transition Model Approach for Turbomachinery Design2015
- Numerical and Theoretical Investigations Concerning the Continuous-Surface-Curvature Effect in Compressor BladesEnergies, 2014
- Leading-edge redesign of a turbomachinery blade and its effect on aerodynamic performanceApplied Energy, 2012
- Raising cycle efficiency by intercooling in air-cooled gas turbinesApplied Thermal Engineering, 2006
- Viscous Flow in a Controlled Diffusion Compressor Cascade With Increasing IncidenceJournal of Turbomachinery, 1990
- The Development of a Second Generation of Controlled Diffusion Airfoils for Multistage CompressorsJournal of Turbomachinery, 1986