Comprehensive investigation of the effect of cryogenic process on machining of Inconel 718 superalloys with uncoated end mills
- 13 June 2024
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part E: Journal of Process Mechanical Engineering
- Vol. 240 (2) , 1571-1583
Abstract
Inconel 718 is extensively used in crucial fields such as aerospace, space researches, and space stations due to its superior features such as high mechanical strength even at very high temperatures, high oxidation resistance, and resistance to high temperatures. However, this material is categorized as a difficult-to-machine material owing to its high specific strength, high tool wear, and low thermal properties leading to poor machinability and poor surface integrity during machining. In order to overcome the challenges that arise during the machining of these materials, the cryogenic process, which has been very popular in recent years, have come to the fore due to the wear resistance and hardness it provides for the tool. In this statistical and experimental study, Inconel 718 was milled with cryogenically uncoated end mill (UCC) and uncoated end mill (UC) at different cutting parameters. Surface roughness, abrasive wear, cutting forces, cutting tool wear, vibration values, hardness and Build up Edge (BUE) formation obtained as a result of machining experiments were investigated. It was determined that the values of all experimental results obtained with UCCs are lower than those of UCs. Also, the second order equations (by response surface methodology (RSM)) showed very promising values of R 2 (above 90%) and thus reflected the appropriate relation of the independent and dependent variables; therefore, RSM approach can be successfully implemented for predicting experimental values in milling Inconel 718 with UCCs and UCs.Keywords
Funding Information
- BTUBAP (2017-GRADUATE-2)
This publication has 35 references indexed in Scilit:
- Effects of Cutting Speed on Chip Characteristics and Tool Wear Mechanisms During Dry Machining of Inconel 718 Using Uncoated WC ToolArabian Journal for Science and Engineering, 2019
- Effect of cryogenic treatment on the microstructure and the wear behavior of WC-Co end mills for machining of Ti6Al4V titanium alloyThe International Journal of Advanced Manufacturing Technology, 2017
- Machinability study and process optimization in face milling of some super alloys with indexable copy face mill insertsJournal of Manufacturing Processes, 2015
- Parametric modeling and optimization for wire electrical discharge machining of Inconel 718 using response surface methodologyThe International Journal of Advanced Manufacturing Technology, 2015
- Investigation of the effects of cryogenic treatment applied at different holding times to cemented carbide inserts on tool wearInternational Journal of Machine Tools and Manufacture, 2014
- Study of machining parameter optimization in high speed milling of Inconel 718 curved surface based on cutting forceThe International Journal of Advanced Manufacturing Technology, 2014
- Analysis of machined surface quality in a single-pass of ball-end milling on Inconel 718Journal of Manufacturing Processes, 2012
- Metallurgical and mechanical characteristics of cryogenically treated tungsten carbide (WC–Co)The International Journal of Advanced Manufacturing Technology, 2011
- Machinability of C45 steel with deep cryogenic treated tungsten carbide cutting tool insertsInternational Journal of Refractory Metals and Hard Materials, 2009
- Performance of cryogenically treated tungsten carbide tools in milling operationsThe International Journal of Advanced Manufacturing Technology, 2006