In-cloud processes of methacrolein under simulated conditions – Part 3: Hygroscopic and volatility properties of the formed Secondary Organic Aerosol
Authors:
Preprint
- 10 March 2009
- preprint
- Published by Copernicus GmbH in EGUsphere
- Vol. 9 (14) , 5119-5130
Abstract
The hygroscopic and volatility properties of secondary organic aerosol (SOA) produced from the nebulization of solutions after aqueous phase photooxidation of methacrolein was experimentally studied in a laboratory, using a Volatility-Hygroscopicity Tandem DMA (VHTDMA). The obtained SOA were 80% 100°C-volatile after 5 h of reaction and only 20% 100°C-volatile after 22 h of reaction. The Hygroscopic Growth Factor (HGF) of the SOA produced from the nebulization of solutions after aqueous-phase photooxidation of methacrolein is 1.34–1.43, which is significantly higher than the HGF of SOA formed by gas-phase photooxidation of terpenes, usually found almost hydrophobic. These hygroscopic properties were confirmed for SOA formed by the nebulization of the same solutions where NaCl was added. The hygroscopic properties of the cloud droplet residuals decrease with the reaction time, in parallel with the formation of more refractory compounds. This decrease was mainly attributed to the 250°C-refractive fraction (presumably representative of the highest molecular weight compounds), which evolved from moderately hygroscopic (HGF of 1.52) to less hygroscopic (HGF of 1.36). Oligomerization is suggested as a process responsible for the decrease of both volatility and hygroscopicity with time. The NaCl seeded experiments enabled us to show that 19±4 mg L−1 of SOA was produced after 9.5 h of reaction and 41±9 mg L−1 after 22 h of in-cloud reaction. Because more and more SOA is formed as the reaction time increases, our results show that the reaction products formed during the aqueous-phase OH-oxidation of methacrolein may play a major role in the properties of residual particles upon the droplet's evaporation. Therefore, the specific physical properties of SOA produced during cloud processes should be taken into account for a global estimation of SOA and their atmospheric impacts.Keywords
All Related Versions
- Published version: Atmospheric Chemistry and Physics, 9 (14), 5119.
This publication has 53 references indexed in Scilit:
- Increase of the aerosol hygroscopicity by cloud processing in a mesoscale convective system: a case study from the AMMA campaignAtmospheric Chemistry and Physics, 2008
- Aqueous-phase ozonolysis of methacrolein and methyl vinyl ketone: a potentially important source of atmospheric aqueous oxidantsAtmospheric Chemistry and Physics, 2008
- Oligomers formed through in-cloud methylglyoxal reactions: Chemical composition, properties, and mechanisms investigated by ultra-high resolution FT-ICR mass spectrometryAtmospheric Environment, 2008
- Thermodynamic Models of Aqueous Solutions Containing Inorganic Electrolytes and Dicarboxylic Acids at 298.15 K. 1. The Acids as Nondissociating ComponentsThe Journal of Physical Chemistry A, 2006
- CCN activation of slightly soluble organics: the importance of small amounts of inorganic salt and particle phaseTellus B: Chemical and Physical Meteorology, 2004
- A novel model to predict the physical state of atmospheric H2SO4/NH3/H2O aerosol particlesAtmospheric Chemistry and Physics, 2003
- Characterization of water‐soluble organic compounds in atmospheric aerosol: A new approachJournal of Geophysical Research: Atmospheres, 2000
- Estimation of water uptake by organic compounds in submicron aerosols measured during the Southeastern Aerosol and Visibility StudyJournal of Geophysical Research: Atmospheres, 2000
- Secondary organic aerosol formation in cloud and fog droplets: a literature evaluation of plausibilityAtmospheric Environment, 2000
- Prediction of multicomponent inorganic atmospheric aerosol behaviorAtmospheric Environment, 1999