Measurement of the high-fielddrop in a high-purity large-grain niobium cavity for different oxidation processes
Authors:
Open Access
- 27 June 2007
- journal article
- research article
- Published by American Physical Society (APS) in Physical Review Special Topics - Accelerators and Beams
- Vol. 10 (6) , 062002
Abstract
The most challenging issue for understanding the performance of superconducting radio-frequency (rf) cavities made of high-purity (residual resistivity ratio ) niobium is due to a sharp degradation (“-drop”) of the cavity quality factor as the peak surface magnetic field () exceeds about 90 mT, in the absence of field emission. In addition, a low-temperature () in situ baking of the cavity was found to be beneficial in reducing the -drop. In this contribution, we present the results from a series of rf tests at 1.7 and 2.0 K on a single-cell cavity made of high-purity large (with area of the order of few ) grain niobium which underwent various oxidation processes, after initial buffered chemical polishing, such as anodization, baking in pure oxygen atmosphere, and baking in air up to , with the objective of clearly identifying the role of oxygen and the oxide layer on the -drop. During each rf test a temperature mapping system allows measuring the local temperature rise of the cavity outer surface due to rf losses, which gives information about the losses location, their field dependence, and space distribution. The results confirmed that the depth affected by baking is about 20–30 nm from the surface and showed that the -drop did not reappear in a previously baked cavity by further baking at in pure oxygen atmosphere or in air up to . These treatments increased the oxide thickness and oxygen concentration, measured on niobium samples which were processed with the cavity and were analyzed with transmission electron microscope and secondary ion mass spectroscopy. Nevertheless, the performance of the cavity after air baking at degraded significantly and the temperature maps showed high losses, uniformly distributed on the surface, which could be completely recovered only by a postpurification treatment at . A statistic of the position of the “hot spots” on the cavity surface showed that grain boundaries are not the preferred location. An interesting correlation was found between the -drop onset, the quench field, and the low-field energy gap, which supports the hypothesis of thermomagnetic instability governing the -drop and the baking effect.
Keywords
This publication has 16 references indexed in Scilit:
- Change in high field Q-slope by baking and anodizingPhysica C: Superconductivity and its Applications, 2006
- Improved oxygen diffusion model to explain the effect of low-temperature baking on high field losses in niobium superconducting cavitiesApplied Physics Letters, 2006
- Review of the frontier workshop and Q-slope resultsPhysica C: Superconductivity and its Applications, 2006
- Effect of low-temperature baking on the radio-frequency properties of niobium superconducting cavities for particle acceleratorsJournal of Applied Physics, 2004
- Use of the titanium solid state gettering process for the improvement of the performance of superconducting r.f. cavitiesJournal of the Less Common Metals, 1988
- On the oxidation and on the superconductivity of niobiumApplied Physics A, 1987
- High Oradient Superconducting Cavities for Storage RingsIEEE Transactions on Nuclear Science, 1985
- Superconducting cavitiesCryogenics, 1976
- Effects of Radiation on Surface Resistance of Superconducting Niobium CavityApplied Physics Letters, 1971
- Gettering of Gas by TitaniumJournal of Applied Physics, 1955