Differential feeding technique for mm‐wave series‐fed antenna‐array
Authors:
Open Access
- 1 July 2013
- journal article
- antennas and-propagation
- Published by Institution of Engineering and Technology (IET) in Electronics Letters
- Vol. 49 (15) , 918-919
Abstract
A differential feeding technique for a broadband planar antenna‐array is presented. The antenna structure is composed of four parallel linear series‐fed arrays of four microstrip patches. To cancel the beam tilt versus frequency, one side of the array is fed with in‐phase signal, whereas the same out‐of‐phase signal feeds the opposite side of the array. A rat‐race balun is especially designed to generate those two signals. In comparison with other feeding techniques, there is no need for a resistive load which is actually a problem at millimeter (mm)‐wave frequencies. To validate the concept, a 60 GHz prototype etched on the TacLamPlus substrate is designed and measured.Keywords
This publication has 6 references indexed in Scilit:
- Efficiency Measurement of Probe-Fed Antennas Operating at Millimeter-Wave FrequenciesIEEE Antennas and Wireless Propagation Letters, 2012
- Development of a Millimeter-Wave Measurement Setup and Dedicated Techniques to Characterize the Matching and Radiation Performance of Probe-Fed Antennas [Measurements Corner]IEEE Antennas and Propagation Magazine, 2012
- A Circularly-Polarized Array Antenna Using Linearly-Polarized Sub Grid Arrays for Highly-Integrated 60-GHz RadioIEEE Transactions on Antennas and Propagation, 2012
- A Ball Grid Array Package With a Microstrip Grid Array Antenna for a Single-Chip 60-GHz ReceiverIEEE Transactions on Antennas and Propagation, 2011
- 60-GHz Patch Antennas and Arrays on LTCC With Embedded-Cavity SubstratesIEEE Transactions on Antennas and Propagation, 2008
- A backward angle-fire array antennaIEEE Transactions on Antennas and Propagation, 1964