Effects of Process Conditions, Material Properties, and Initial Shape of Flaw on the Deformation Behavior of Surface Flaw during Wire Drawing
- 15 November 2019
- journal article
- research article
- Published by Iron and Steel Institute of Japan in ISIJ International
- Vol. 59 (11) , 2052-2061
Abstract
No abstract availableKeywords
This publication has 28 references indexed in Scilit:
- Investigation of process parameters effect on the copper-wire drawingMaterials & Design (1980-2015), 2009
- Processing map approach for surface defect prediction in the hot bar rollingJournal of Materials Processing Technology, 2008
- Inhomogeneous deformation and residual stress in skin-pass axisymmetric drawingJournal of Materials Processing Technology, 2008
- Plastic work approach for surface defect prediction in the hot bar rolling processJournal of Materials Processing Technology, 2007
- Deformation behavior of the surface defects of low carbon steel in wire rod rollingJournal of Materials Processing Technology, 2007
- Deformation analysis of surface flaws in stainless steel wire drawingJournal of Materials Processing Technology, 2005
- Deformation Analysis of Surface Crack in Rolling and Wire DrawingJSME International Journal Series A, 2005
- Modelling and measurements of mechanical behaviour in multi-pass drawing processJournal of Materials Processing Technology, 1998
- A computational study of strain inhomogeneity in wire drawingInternational Journal of Machine Tools and Manufacture, 1995
- Inhomogeneity of mechanical properties in stainless steel rods after drawingJournal of Materials Processing Technology, 1994