Correlation between Compressive Strength and Heat of Hydration of Cement Mortars with Siliceous Fly Ash
Open Access
Abstract
This paper presents the results of calorimetric and strength tests of mortars with ordinary Portland cement and two substitution rates (10 and 20%) of cement by siliceous fly ash. The prepared samples were cured under isothermal conditions at four different temperatures: 23, 33, 43 and 53 °C. Heat of hydration was measured using an isothermal calorimeter dedicated to monitor the hydration process of cementitious composites such as paste, mortar and concrete. Thermal data were recorded continuously for 7 days, while compression tests were performed at 6 h and 1, 2, 5, 7 and 14 days of hardening. The studies proved that the amount of heat released correlates with the early-age strength of 50 mm mortar cubes. In the case of samples cured at 23 and 53 °C, a linear relationship between the heat of hydration and compressive strength was observed. The high value of the coefficient of determination (R2) allows one to estimate the mortar compressive strength after 7 and 14 days based on hydration heat tests conducted at standard temperature (23 °C), regardless of the percentage of siliceous fly ash. The increased curing temperatures do not guarantee a high correlation between compressive strength and the amount of heat released.Keywords
This publication has 24 references indexed in Scilit:
- Using isothermal calorimetry to predict one day mortar strengthsCement and Concrete Research, 2016
- Heat of hydration of low-clinker cementsJournal of Thermal Analysis and Calorimetry, 2015
- Hydration of Portland cement with high replacement by siliceous fly ashCement and Concrete Research, 2012
- Relating Compressive Strength to Heat Release in MortarsAdvances in Civil Engineering Materials, 2012
- A review of the multi-component utilisation of coal fly ashFuel, 2012
- The early hydration of Ordinary Portland Cement (OPC): An approach comparing measured heat flow with calculated heat flow from QXRDCement and Concrete Research, 2012
- A gap-graded particle size distribution for blended cements: Analytical approach and experimental validationPowder Technology, 2011
- A new approach in quantitative in-situ XRD of cement pastes: Correlation of heat flow curves with early hydration reactionsCement and Concrete Research, 2011
- Characterization and Performance Prediction of Cement-Based Materials Using a Simple Isothermal CalorimeterJournal of Advanced Concrete Technology, 2009
- Heat of hydration of Portland Cement–Metakaolin–Fly ash (PC–MK–PFA) blendsCement and Concrete Research, 2008