Quench, normal zone propagation velocity, and the development of an active protection scheme for a conduction cooled, react-and-wind, MgB2 MRI coil segment
- 23 October 2019
- journal article
- research article
- Published by IOP Publishing in Superconductor Science and Technology
- Vol. 32 (12) , 125003
Abstract
The development of coils that can survive a quench is crucial for demonstrating the viability of MgB2-based main magnet coils used in MRI systems. Here we have studied the performance and quench properties of a large (outer diameter: 901 mm; winding pack: 44 mm thick × 50.6 mm high) conduction-cooled, react-and-wind (R&W), MgB2 superconducting coil. Minimum quench energy (MQE) values were measured at several coil operating currents (Iop), and distinguished from the minimum energy needed to generate a normal zone (MGE). During these measurements, normal zone propagation velocities (NZPV) were also determined using multiple voltage taps placed around the heater zone. The conduction cooled coil obtained a critical current (Ic) of 186 A at 15 K. As the operating currents (Iop) varied from 80 A to 175 A, MQE ranged from 152 J to 10 J, and NZPV increased from 1.3 to 5.5 cm/s. Two kinds of heater were involved in this study: (1) a localized heater (“test heater”) used to initiate the quench, and (2) a larger “protection heater” used to protect the coil by distributing the normal zone after a quench was detected. The protection heater was placed on the outside surface of the coil winding. The test heater was also placed on the outside surface of the coil at a small opening made in the protection heater. As part of this work, we also developed and tested an active protection scheme for the coil. Such active protection schemes are of great interest for MgB2-based MRIs because they permit exploitation of the relatively large MQE values of MgB2 to enable the use of higher Je values which in turn lead to competitive MgB2 MRI designs. Finally, the ability to use a quench detection voltage to fire a protection heater as part of an active protection scheme was also demonstrated.Keywords
Funding Information
- National Institute of Biomedical Imaging and Bioengineering (R01EB018363)
- National Institutes of Health (5R44CA144415-06)
This publication has 38 references indexed in Scilit:
- Critical current densities of doped MgB2 strands in low and high applied field ranges: The Jc(B) crossover effectPhysica C: Superconductivity and its Applications, 2013
- Active Protection of an ${
m MgB}_{2}$ Test CoilIEEE Transactions on Applied Superconductivity, 2011
- Relation Between Transverse and Longitudinal Normal Zone Propagation Velocities in Impregnated ${\rm MgB}_{2}$ WindingsIEEE Transactions on Applied Superconductivity, 2009
- The effect of the wire design parameters on the stability of MgB2superconducting coilsSuperconductor Science and Technology, 2009
- Normal Zone Propagation in a ${\rm MgB}_{2}$ Conduction Cooled Test MagnetIEEE Transactions on Applied Superconductivity, 2008
- Quench development and propagation in metal/MgB2conductorsSuperconductor Science and Technology, 2005
- Stability and Protection of Superconducting Magnets—A DiscussionIEEE Transactions on Applied Superconductivity, 2005
- Quench characteristics and normal zone propagation of an MgB2superconducting coilSuperconductor Science and Technology, 2003
- Stability and quench of a HTS magnet with a hot spotSuperconductor Science and Technology, 2000
- A numerical model for stability considerations in HTS magnetsSuperconductor Science and Technology, 2000