Thermal Durability of Wall-Flow Ceramic Diesel Particulate Filters
Authors:
- 5 March 2001
- conference paper
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Abstract
The maximum use temperature of a diesel particulate filter is often thought to be limited only by the melting point of the filter material itself. This paper suggests that the maximum practical use temperature for filters is limited not by the intrinsic filter melting temperature, but by the temperature at which the metal oxide ash collected from the engine exhaust sinters and adheres to the filter wall, or the temperature at which the filter undergoes eutectic melting by reaction with the ash. Ash sintering and adherence without reaction with the filter material may result in loss of filter permeability and a permanent pressure drop increase. Chemical reactions between the ash and the filter can result either in pinholes through the walls, which compromise filtration efficiency, or glazing on the surface of the walls, which increases back pressure. These metal oxide deposits that comprise the ash are derived from engine wear, oil additives, fuel additives, and corrosion of the manifold and other exhaust system components. Excessive temperatures can be avoided by employing sophisticated regeneration controls and/or by employing filters that have a high volumetric heat capacity and/or a high thermal conductivity. Several new monolithic DPFs are under development that exhibit a unique combination of high thermal shock resistance and high volumetric heat capacity. Temperatures generated within these filters during uncontrolled regenerations are substantially lower than those observed for other ceramic oxide filters, resulting in little or no reaction between the filter and ash under severe operating conditions.Keywords
This publication has 26 references indexed in Scilit:
- Considerations on the Temperature Distribution and Gradient in the Filter During Regeneration in Burner Type Diesel Particulate Trap System (II)SAE International Journal of Advances and Current Practices in Mobility, 1998
- A Study of the Regeneration Process in Diesel Particulate Traps Using a Copper Fuel AdditiveSAE International Journal of Advances and Current Practices in Mobility, 1996
- Development of a Full-Flow Burner Regeneration Type Diesel Particulate Filter Using SiC HoneycombSAE International Journal of Advances and Current Practices in Mobility, 1996
- Thermal Loading in SiC Particle FiltersSAE International Journal of Advances and Current Practices in Mobility, 1995
- Development of a Diesel Particulate Filter Composition and Its Effect on Thermal Durability and Filtration PerformanceSAE International Journal of Advances and Current Practices in Mobility, 1994
- Study of SiC Application to Diesel Particulate Filter (Part 2): Engine Test ResultsSAE International Journal of Advances and Current Practices in Mobility, 1993
- Improvement of Pore Size Distribution of Wall Flow Type Diesel Particulate FilterSAE International Journal of Advances and Current Practices in Mobility, 1992
- Thermal Durability of a Ceramic Wall-Flow Diesel Filter for Light Duty VehiclesSAE International Journal of Advances and Current Practices in Mobility, 1992
- Electric Heating Regeneration of Large Wall-Flow Type DPFSAE International Journal of Advances and Current Practices in Mobility, 1991
- Development of a Particulate Trap System for a Heavy-Duty Diesel EngineSAE International Journal of Advances and Current Practices in Mobility, 1988