A New Method to Calculate Instantaneous Vehicle Emissions using OBD Data
Authors:
- 12 April 2010
- conference paper
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Abstract
The actual type approval procedure of vehicles, based on a fixed driving cycle for all the vehicles (NEDC), is not representative of their real on-road usage: the driving style and its influence on consumption and emissions cannot be neglected. The on-road impact of vehicles on their real use is not known and it is difficult to measure (the PEMS are expensive, have big volume and mass and need continuous maintenance); the objective of this work is to develop a methodology to calculate in real time the energy and environmental impact of spark ignition vehicles, using the onboard sensors of the vehicle and emissions models to calculate them.An onboard instrumentation able to communicate with the electronic system of the vehicle (OBD/CAN) was developed to collect all the sensor data installed on a vehicle: those values are used as input values to the emissions models of CO₂, CO, HC and NOx developed in the present work. The CO₂ and CO have been calculated using a chemical equilibrium combustion model with 6 combustion products, with the equilibrium temperature used as a calibration constant. HC and NOx, produced during transients, are assumed to be dependent from the accelerator pedal gradient, but during engine cold start also from the catalyst temperature.To validate the models, a spark ignition hybrid vehicle, the Honda Civic Hybrid has been tested on a chassis dynamometer running the three Artemis driving cycles. The emissions have been measured with the CVS (taken as reference) and with a portable emission analyzer, (Horiba OBS 1300), used for comparison with the models. The results shows that the values calculated by the models are comparable with those measured by OBS, but for HC and NOx are better because the OBS gave inaccuracies due to its high minimum resolution.Keywords
This publication has 8 references indexed in Scilit:
- Experimental Measurement of the Environmental Impact of a Euro IV Vehicle in its Urban UseSAE International Journal of Advances and Current Practices in Mobility, 2007
- Performance Test Results of a New On Board Emission Measurement System Conformed with CFR Part 1065SAE International Journal of Advances and Current Practices in Mobility, 2007
- A new method for collecting vehicle behaviour in daily use for energy and environmental analysisProceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering, 2006
- Real-world European driving cycles, for measuring pollutant emissions from high- and low-powered carsAtmospheric Environment, 2006
- The ARTEMIS European driving cycles for measuring car pollutant emissionsScience of The Total Environment, 2004
- Describing and compensating gas transport dynamics for accurate instantaneous emission measurementAtmospheric Environment, 2003
- Modelling of Motor Vehicle Fuel Consumption and Emissions Using a Power-Based ModelEnvironmental Monitoring and Assessment, 2000
- Modelling of Motor Vehicle Fuel Consumption and Emissions Using a Power-Based Model2000