Prediction of grain size and yield strength of Mg-7Sn-1Al-1Zn alloys extruded at various temperatures and speeds
Authors:
- 19 March 2014
- journal article
- Published by Springer Nature in Metals and Materials International
- Vol. 20 (2) , 291-296
Abstract
No abstract availableKeywords
This publication has 29 references indexed in Scilit:
- Effects of extrusion speed on the microstructure and mechanical properties of ZK60 alloys with and without 1wt% cerium additionMaterials Science and Engineering: A, 2013
- Extrudability and Tensile Properties of the Mg-7Sn-1Al-1Zn AlloyKorean Journal of Metals and Materials, 2013
- Strain-dependent constitutive analysis of hot deformation and hot workability of T4-treated ZK60 magnesium alloyMetals and Materials International, 2013
- High temperature deformation behavior of Mg-Sn(-Zn) alloyMetals and Materials International, 2011
- Enhanced mechanical properties in fine-grained Mg–1.0Zn–0.5Ca alloys prepared by extrusion at different temperaturesScripta Materialia, 2010
- Microstructure and mechanical properties of an indirect-extruded Mg–8Sn–1Al–1Zn alloyMaterials Letters, 2010
- Heat-treatable Mg–Sn–Zn wrought alloyScripta Materialia, 2009
- A high-strength Mg–Sn–Zn–Al alloy extruded at low temperatureScripta Materialia, 2008
- Development of creep resistant die cast Mg–Sn–Al–Si alloyMaterials Science and Engineering: A, 2005
- Influence of grain size on hot working stresses and microstructures in Mg–3Al–1ZnScripta Materialia, 2004