Role of Reversed Austenite Behavior in Determining Microstructure and Toughness of Advanced Medium Mn Steel by Welding Thermal Cycle
Open Access
Abstract
Reversed austenite transformation behavior plays a significant role in determining the microstructure and mechanical properties of heat affected zones of steels, involving the nucleation and growth of reversed austenite. Confocal Laser Scanning Microscope (CLSM) was used in the present work to in situ observe the reversed austenite transformation by simulating welding thermal cycles for advance 5Mn steels. No thermal inertia was found on cooling process after temperature reached the peak temperature of 1320 °C. Therefore, too large grain was not generated in coarse-grained heat-affected zone (CGHAZ). The pre-existing film retained austenite in base metal and acted as additional favorable nucleation sites for reversed austenite during the thermal cycle. A much great nucleation number led to the finer grain in the fine-grained heat-affected zone (FGHAZ). The continuous cooling transformation for CGHAZ and FGHAZ revealed that the martensite was the main transformed product. Martensite transformation temperature (Tm) was higher in FGHAZ than in CGHAZ. Martensite transformation rate was higher in FGHAZ than in CGHAZ, which is due to the different grain size and assumed atom (Mn and C) segregation. Consequently, the softer martensite was measured in CGHAZ than in FGHAZ. Although 10~11% austenite retained in FGHAZ, the possible Transformation Induced Plasticity (TRIP) effect at −60 °C test temperature may lower the impact toughness to some degree. Therefore, the mean absorbed energy of 31, 39 and 42 J in CGHAZ and 56, 45 and 36 J in FGHAZ were exhibited at the same welding heat input. The more stable retained austenite was speculated to improve impact toughness in heat-affected zone (HAZ). For these 5Mn steels, reversed austenite plays a significant role in affecting impact toughness of heat-affected zones more than grain size.Keywords
Funding Information
- National Natural Science Foundation of China (51809161)
- Natural Science Foundation of Shanghai Municipality (18ZR1416000)
This publication has 14 references indexed in Scilit:
- Partition and non-partition transition of austenite growth from a ferrite and cementite mixture in hypo- and hypereutectoid Fe-C-Mn alloysCalphad, 2018
- Austenite Grain Growth Kinetics after Isothermal Deformation in Microalloyed Steels with Varying Nb ConcentrationsISIJ International, 2018
- The growth behavior of austenite grain in the heating process of 300M steelMaterials Science and Engineering: A, 2011
- Development of microstructural banding in low-alloy steel with simulated Mn segregationMetallurgical and Materials Transactions A, 2002
- Advances in Physical Metallurgy and Processing of Steels. Physical Metallurgy of Modern High Strength Steel Sheets.ISIJ International, 2001
- Effect of initial grain size on microstructure and toughness of intercritical heat-affected zone of a low carbon steelMaterials Science and Engineering: A, 2000
- Effect of TiN particles and microstructure on fracture toughness in simulated heat-affected zones of a structural steelMetallurgical and Materials Transactions A, 1999
- Five Decades of the Zener Equation.ISIJ International, 1998
- Austenite grain growth kinetics in Al-killed plain carbon steelsMetallurgical and Materials Transactions A, 1996
- The formation of austenite in a low-alloy steelMetallurgical Transactions A, 1980