Effect of Heat Treatment Prior to Direct Hot-Extrusion Processing of Al–Cu–Li Alloy
Open Access
Abstract
This study presents and explains the results of the first steps in developing high strength aluminium alloy (Al–Cu–Li) wires for the ultimate purpose of using them as feedstock for DED (directed energy deposition) techniques, such as wire arc additive manufacturing (WAAM). Powder metallurgy (PM) is proposed as the method to produce the wires due to the high flexibility to adapt the composition and the lower temperatures used with respect to casting. Two PM routes are proposed. The first route comprises blending of the powders, uniaxial pressing, and hot extrusion of the green compact to obtain a bar; the second route includes a heat treatment of the green compact, to promote the diffusion of the alloying elements before hot extrusion. Further steps, such as rolling or drawing, are necessary to obtain the wire from the bar. This work studies the effects of the processing parameters on the properties of extruded bars and compares the results of the two routes employed, with special attention paid to the effects of heat treatment. The study confirms that heat treatment homogenises the microstructure and requires higher applied extrusion force and time. The results from characterisation show the presence of Al–Cu and Al–Cu–Li phases in the microstructure.Keywords
Funding Information
- Regional Government of Madrid (S2018/NMT4411)
This publication has 16 references indexed in Scilit:
- Continuous extrusion of a commercially pure titanium powder via the Conform processMaterials Science and Technology, 2017
- Optimization of Aluminium Extrusion Process using Taguchi MethodIOSR Journal of Mechanical and Civil Engineering, 2017
- Microstructural and mechanical characterisation of 7075 aluminium alloy consolidated from a premixed powder by cold compaction and hot extrusionMaterials & Design (1980-2015), 2014
- The influence of Cu/Li ratio on precipitation in Al–Cu–Li–x alloysActa Materialia, 2013
- Characterisation of Conform™ and conventionally extruded Al–4Mg–1Zr. Effect of extrusion route on superplasticityJournal of Materials Science, 2010
- Effect of the heat treatment prior to extrusion on the direct hot-extrusion of aluminium powder compactsJournal of Alloys and Compounds, 2009
- Microstructure control of continuously porous t-ZrO2 bodies fabricated by multi-pass extrusion processMaterials Science and Engineering: A, 2006
- Diffusion coefficients of some solutes in fcc and liquid Al: critical evaluation and correlationMaterials Science and Engineering: A, 2003
- Alloy Phase Diagrams ProvisionalBulletin of Alloy Phase Diagrams, 1982
- ‘Conform’ Continuous Extrusion of Metal Powders into Products for Electrical Industry: Development ExperiencePowder Metallurgy, 1979