Durability Properties of Concrete Made with High Volumes of Low-Calcium Coal Bottom Ash As a Replacement of Two Types of Sand
- 1 April 2016
- journal article
- research article
- Published by American Society of Civil Engineers (ASCE) in Journal of Materials in Civil Engineering
- Vol. 28 (4)
Abstract
Two types of concrete mixtures (Concrete A and Concrete B) were prepared with sands having different fineness modulus. Sand was replaced with coal bottom ash (CBA) at 20, 30, 40, 50, 75, and 100% levels in both concrete mixtures. Laboratory tests were performed to study the effect of CBA on compressive strength, sorptivity, chloride permeability, drying shrinkage, and sulfate and acid resistance of concrete. At 7 days, for both grades of concretes, concrete mixtures incorporating CBA showed lower compressive strength. At 28 days, for Concrete A, no significant effect of CBA on compressive strength was observed. However, in case of Concrete B, concrete mixtures containing more than 50% CBA displayed lower 28-day compressive strength than that of control concrete. With age, compressive strength of bottom ash concrete mixtures increased at faster rate. Bottom ash concrete mixtures displayed higher sorptivity, lower chloride permeability, and drying shrinkage. For both grades of concretes, resistance to sulfate and acid exposure of control and bottom ash concrete mixtures were almost identical. Compressive strength of concrete mixtures increased up to 180 days of immersion in sulfate solution. Under acid attack, control and bottom ash concrete mixtures experienced almost equal weight loss.Keywords
This publication has 14 references indexed in Scilit:
- Compressive strength prediction of Portland cement concrete with age using a new modelHBRC Journal, 2014
- Correlation between compressive strength and certain durability indices of plain and blended cement concretesCement and Concrete Composites, 2009
- Properties of concrete prepared with crushed fine stone, furnace bottom ash and fine recycled aggregate as fine aggregatesConstruction and Building Materials, 2009
- THE REGULATION OF STRUCTURAL PARAMETERS OF CERAMICS DEPENDING ON THE DRYING REGIMEJOURNAL OF CIVIL ENGINEERING AND MANAGEMENT, 2009
- A method to determine water retainability of porous fine aggregate for design and quality control of fresh concreteConstruction and Building Materials, 2007
- Strength and drying shrinkage properties of concrete containing furnace bottom ash as fine aggregateConstruction and Building Materials, 2005
- Use of conditioned PFA as a fine aggregate component in concreteMaterials and Structures, 2000
- Pozzolanic properties of pulverized coal combustion bottom ashCement and Concrete Research, 1999
- Investigation of Lignite-Based Bottom Ash for Structural ConcreteJournal of Materials in Civil Engineering, 1996
- Influence of Surface Finish on Sorptivity on ConcreteJournal of Materials in Civil Engineering, 1993